| auszookers.com http://auszookers.com/forum/ |
|
| Easy bull bar for GV http://auszookers.com/forum/viewtopic.php?f=14&t=10109 |
Page 1 of 1 |
| Author: | coneykid [ Fri Feb 26, 2010 1:50 pm ] |
| Post subject: | Easy bull bar for GV |
i have sold this car now but i notice there a lot of GV's with out bullbars. I made mine out of a GU patrol ute bull bar. I removed head light bars and had to weld a piece of flat off original mount braket and it slide straight into my chassie rail. thats it... was such a easy fit and was not to heavy. you should of seen the patrol boys when they saw it fit 
|
|
| Author: | coneykid [ Fri Feb 26, 2010 1:54 pm ] |
| Post subject: | Re: Easy bull bar for GV |
i also had to cut it down were the gard finshed.. but very cheap bull bar... |
|
| Author: | want33s [ Fri Feb 26, 2010 2:02 pm ] |
| Post subject: | Re: Easy bull bar for GV |
I've got an alloy GQ bar here if anyone wants it to cut for a GV... FREE. |
|
| Author: | Joe [ Fri Feb 26, 2010 3:10 pm ] |
| Post subject: | Re: Easy bull bar for GV |
Well done matey thats a nice GV i like the rims on it 
|
|
| Author: | coneykid [ Fri Feb 26, 2010 3:18 pm ] |
| Post subject: | Re: Easy bull bar for GV |
its amazing how they clean up after the thrashing you give them.. |
|
| Author: | ODA1 [ Fri Feb 26, 2010 3:32 pm ] |
| Post subject: | Re: Easy bull bar for GV |
i had seen it for sale and wondered about the bar,..... want to make more?? |
|
| Author: | coneykid [ Fri Feb 26, 2010 3:37 pm ] |
| Post subject: | Re: Easy bull bar for GV |
i thought about making a few when i did mine but i had a 2 inch body lift.. so were the chassie bracket goes will very... i going to start making boat trailers on the side one my shed finished so i might do custom bars too. be few months away though.. |
|
| Author: | Mugwui [ Fri Feb 26, 2010 5:21 pm ] |
| Post subject: | Re: Easy bull bar for GV |
want33s wrote: I've got an alloy GQ bar here if anyone wants it to cut for a GV... FREE.
I'll give it a crack Jas! |
|
| Author: | want33s [ Fri Feb 26, 2010 6:26 pm ] |
| Post subject: | Re: Easy bull bar for GV |
Mugwui wrote: want33s wrote: I've got an alloy GQ bar here if anyone wants it to cut for a GV... FREE. I'll give it a crack Jas! Come get it. 
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|