if wheel bearings are gonna cost you $700 you need to look else where.

you gonna pay about $70 tops per side

pull the hubs apart your self.

get a mechanic to press the old out and the new in for maybe $50

and put it all back together.

you dont need new hubs. nor will you find them new these days i doubt

X2.

Also, not a hard job for a novice either...

For $700 are you intentionally looking to get ripped off? Who quoted that?

buy this : http://www.suzistore.com.au/shopexd.asp?id=1385 then buy http://www.suzistore.com.au/shopexd.asp?id=1694 or buy some of weaves. i think genuine would be cheaper than $700 ahaha

seriously do part of it your self.

its not a hard job

$630 for all those.. would be better off getting it in the shop hahaha

Front hubs from repco around 115 each possibly cheaper., bearings installed and all.

Did mine on a xl7 which has abs paid cheaper, because of a mate, but took me around 30min each side to do. Its pretty easy.

I saw some sites selling the Hubs as same part from Vitara, Grand Vitara and XL-7, for Vitara just remove the ABS ring. All it is is the lock ring holding it on, but cant say for sure if the GV Hubs will actually fit on a vitara.

Instructions:
viewtopic.php?f=5&t=36274