| auszookers.com http://auszookers.com/forum/ |
|
| Distributor troubles http://auszookers.com/forum/viewtopic.php?f=37&t=40767 |
Page 1 of 1 |
| Author: | pickles09 [ Tue May 07, 2013 10:33 pm ] |
| Post subject: | Distributor troubles |
Distributor out of a g16a won't go back into housing won't go in all the way as you can see on this dizzy there's a nipple on the end of the shaft this was not present in my old engine which was a g16b any ideas? http://i.imgur.com/SBdetVu.jpg http://i.imgur.com/DIvquLY.jpg |
|
| Author: | Rhinoman [ Wed May 08, 2013 9:10 pm ] |
| Post subject: | Re: Distributor troubles |
Did it come out of the engine you're trying it fit it into? When you say 'nipple' do you mean the extended part of the shaft below the cam gear? the G16A 8V dizzys do have those but if the engine has a G13 dizzy housing then it won't fit as the shaft on the G13 dizzy stops at the bottom of the cam gear. |
|
| Author: | pickles09 [ Thu May 09, 2013 12:06 am ] |
| Post subject: | Re: Distributor troubles |
It actually came out of a g16b and then I tried another distributor in the engine then I went to put this one back in and it wouldn't go back in weird . Yes the extended shaft is what I'm talking about ! Do g13 distributors fit? |
|
| Author: | losfer [ Thu May 09, 2013 5:41 pm ] |
| Post subject: | Re: Distributor troubles |
thats a 1.3 sierra distributor , not a g16 dizzy... |
|
| Author: | Rhinoman [ Thu May 09, 2013 5:46 pm ] |
| Post subject: | Re: Distributor troubles |
I must have confused the two, I do recall having to swap the dizzy housing when I did the 1.6 conversion. I'm sure you're right as I think it was the 1.3 dizzy that I ran originally. |
|
| Author: | losfer [ Thu May 09, 2013 9:18 pm ] |
| Post subject: | Re: Distributor troubles |
the second part of the part number starts with 83xxx which is always sierra , vitara use 60a or 61a or another combination for the efi part numbers . and the vitara dizzy doesnt have that extra bit of shaft after the drive gear . also the vitara just uses a 2 pin socket . the dizzy in the pic has wires that connect to the coil and a seperate wire on the negative that goes to the tacho . |
|
| Author: | losfer [ Thu May 09, 2013 9:22 pm ] |
| Post subject: | Re: Distributor troubles |
also the reason you had to swap the dizzy housing is because the vitara camshaft is about 10mm shorter than the sierra camshaft |
|
| Author: | Rhinoman [ Thu May 09, 2013 9:31 pm ] |
| Post subject: | Re: Distributor troubles |
losfer wrote: also the reason you had to swap the dizzy housing is because the vitara camshaft is about 10mm shorter than the sierra camshaft Thats right, the 1.6 housing looks the same but isn't machined to take the longer shaft. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|
