| auszookers.com http://auszookers.com/forum/ |
|
| 1L case questions http://auszookers.com/forum/viewtopic.php?f=37&t=42613 |
Page 1 of 1 |
| Author: | coily96 [ Fri Aug 23, 2013 9:35 pm ] |
| Post subject: | 1L case questions |
The 1L case has two single wires with a terminal on each The coily has a round plug. To get the light to work on the dash is it just the case of cutting the plug off the coily case and wiring it to the 1L case. Will polarity cause a short? Also i ordered a new bush for the selector, went to install it and there wasnt a bush inside the 1L case. It has a cone shaped spring and the peice that locks the selector stick into place. Also |
|
| Author: | rwt65 [ Mon Aug 26, 2013 5:46 pm ] |
| Post subject: | Re: 1L case questions |
Coily speedo cable bolts straight in and so will your Coily 4wd switch so you don't need to rewire anything.. |
|
| Author: | coily96 [ Mon Aug 26, 2013 6:57 pm ] |
| Post subject: | Re: 1L case questions |
Im missing the plug on the 1L end. Speedo cable went straight in thankyou. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|