viewtopic.php?f=14&t=5293
| auszookers.com http://auszookers.com/forum/ |
|
| Converting Front Spring Spacing from WT to NT http://auszookers.com/forum/viewtopic.php?f=37&t=47899 |
Page 1 of 1 |
| Author: | Hybrid [ Tue Sep 23, 2014 7:18 pm ] |
| Post subject: | Converting Front Spring Spacing from WT to NT |
I'm asking this here as I'm sure I should be able to find it but cant. Can someone point me to a write up on the conversion. I'm doing a chassis extension RUF on the backup sierra and figured I may as well NT it at the same time. Cheers, John |
|
| Author: | atari4x4 [ Wed Sep 24, 2014 11:28 pm ] |
| Post subject: | Re: Converting Front Spring Spacing from WT to NT |
| viewtopic.php?f=14&t=5293
|
|
| Author: | neofitou [ Sat Sep 27, 2014 11:17 am ] |
| Post subject: | Re: Converting Front Spring Spacing from WT to NT |
Also check out my samurai build, it's easier if you don't cut off the whole perch until after you have the new ones in position. viewtopic.php?f=4&t=39049&hilit=samurai&start=60 |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|