auszookers.com
http://auszookers.com/forum/

Jimny throwout bearing sticking
http://auszookers.com/forum/viewtopic.php?f=37&t=47954		 Page 1 of 1
Author:  Jezza86 [ Mon Sep 29, 2014 5:39 pm ]
Post subject:  Jimny throwout bearing sticking
Hi Guys
My bearings are making my clutch stick. figure they need doing the amount of water and mud I make the car swim through

so if I'm pulling out the gearbox I should also do what? Main rear seal i have heard, and been told to go genuine on that...
my clutch? (It sometimes shudders, probably from the grease thats suposed to be on the spigot.)

and after telling me what to buy, any suggestions on where to buy it incase i cant get it all from 4wd_products
Author:  atari4x4 [ Mon Sep 29, 2014 5:51 pm ]
Post subject:  Re: Jimny throwout bearing sticking
You need a stage42 11ty puk, brass nipple racing crutch.
Author:  Scrawny [ Mon Sep 29, 2014 6:00 pm ]
Post subject:  Re: Jimny throwout bearing sticking
If you can, get the flywheel machined. The shudders are from hot (high) spots on the flywheel and pressure plate.
Author:  Jezza86 [ Mon Sep 29, 2014 7:15 pm ]
Post subject:  Re: Jimny throwout bearing sticking
not a option in town but thanks for the info. after 20 000 km im going to take the gamble on it only being mud and grease.
thanks atari, Exedy SZK-7245HDB in the cart
Image

seriously but. spigot bearings?
Author:  Jezza86 [ Mon Sep 29, 2014 7:25 pm ]
Post subject:  Re: Jimny throwout bearing sticking
SZK-7245HD clutch $425.00 (suzistore)
DCT-47 alignment tool (dunno)
6002LLU spigot bearing/ bush. (Dunno)

Rear main oil seal 65 bucks (suzistore)

anything else to add?
Author:  henno [ Mon Sep 29, 2014 7:27 pm ]
Post subject:  Re: Jimny throwout bearing sticking
The spigot bearing should be cheap as chips. Like, 8 bucks cheap.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/