Yeah theyre fine, a little too overpriced, but ok. Try kmart, target, big W, repco are grossly overpriced. They charge $18 for the same type of buckles i use which at cost price are $2.55. The bolt kits, well, i have a shit load which i get as freebies from new seats, that the car already has anchor lovations.

I can post a couple of anchor bolt kits and buckles to you if you want.

Im going to do a write up later this arvo, so stay tuned.

Yep thats the spot for it.

You will only need to use the small spacer, spring washer and of course bolt. Everything else, throw it on your neighbours lawn.

sierra's have the anchor point on the back of the seat.

I haven't had a chance to get photo's and do a complete write up but I just googled images for a gated buckle to illistrate, then I saw a familiar hand.. Turns out I've covered this on here before.. ---> viewtopic.php?f=5&t=25867

What side is the footpath side of the road?
If a car were to run a red light and t bone you, where would it hit?

8/10 single seat installs i do go on the passanger side.

Yeeah, now go make some babies

Spring washer should be between the bolt head and bracket, but no big deal.

If you are only having the restraint in there temporarily, just feed the seat belt through the back of the kids seat, put your knee into it and pull on the top part of the cars seat belt and hard as you can. Then put the tether strap on.

If it's going to be in there for a while, use a gated buckle.

vits are pretty easy except the seat belt clips are to long and can be a pain to get tight enough. for bonus points install 2 into a dual cab ute I hated having to take the seats out of our old courier and all seats aren't created equal some of the rear strap design shit me to tears. glad my 2 are in booster with lap sash now.