| auszookers.com http://auszookers.com/forum/ |
|
| Missing Oring Fuel Cut off Solenoid 1.3l motor http://auszookers.com/forum/viewtopic.php?f=37&t=48360 |
Page 1 of 1 |
| Author: | Tonner [ Fri Nov 07, 2014 9:32 pm ] |
| Post subject: | Missing Oring Fuel Cut off Solenoid 1.3l motor |
Having a few issues with stalling once the car is hot as soon as you put the clutch in so thought I would start by replacing all the vacuum lines and cleaning the fuel cut off solenoid. When I pulled the solenoid out the o-ring was missing, had a bit of a fish around up the port it came out of in case it came off when I removed it but didn't manage to find the o-ring so I figured it wasn't there to start with. Put it back in wired it up and hit the key and it ran and idled fine. What happens if the o-ring is not replaced? I don't want to come out and find a big puddle of fuel under the car in the morning. Could this be the problem I had with stalling when it got hot. I should mention the stalling only happened after restarting from a 10 minute stop for my son to show his mates the new car, Previously I had driven about 40kms with no issues stopping and accelerating away from lights etc Appreciate any help........................anyone interested in rebuilding the carb for me for a few bucks? |
|
| Author: | fordem [ Fri Nov 07, 2014 11:20 pm ] |
| Post subject: | Re: Missing Oring Fuel Cut off Solenoid 1.3lt motor |
If you're referring to the solenoid near the top of the carb throat (I know it as the anti-dieseling solenoid) - I don't recall any O-rings - all it does is block an air passage in the carb so there will be no fuel leakage, and that was probably not the cause of the engine stalling - if it was, it would have stalled as soon as you took your foot off the gas. |
|
| Author: | coily96 [ Fri Nov 07, 2014 11:59 pm ] |
| Post subject: | Re: Missing Oring Fuel Cut off Solenoid 1.3lt motor |
Mine had an o ring when i removed it and one came in the carby kit. They can fall off inside the carby when installing the solenoid. |
|
| Author: | coily96 [ Sat Nov 08, 2014 12:04 am ] |
| Post subject: | Re: Missing Oring Fuel Cut off Solenoid 1.3lt motor |
viewtopic.php?f=5&t=39612&hilit=fuel+cut+solenoid |
|
| Author: | Tonner [ Sat Nov 08, 2014 9:17 am ] |
| Post subject: | Re: Missing Oring Fuel Cut off Solenoid 1.3lt motor |
coily96 wrote: http://www.auszookers.com/forum/viewtopic.php?f=5&t=39612&hilit=fuel+cut+solenoid Yeah found this a couple of days ago and is exactly what I was doing when I pulled it out the o-ring wasn't there, just a bit concerned its missing |
|
| Author: | coily96 [ Tue Nov 11, 2014 8:35 pm ] |
| Post subject: | Re: Missing Oring Fuel Cut off Solenoid 1.3lt motor |
A new o ring comes in a carby kit. But the shop that installed the kit lost both of mine. I bought a o ring kit from supercheap and used that. When i had carby problems i removed this fuel cut off switch and put a bolt in there. Over runs now and again but not every time. |
|
| Author: | Tonner [ Thu Nov 13, 2014 8:59 pm ] |
| Post subject: | Re: Missing Oring Fuel Cut off Solenoid 1.3lt motor |
coily96 wrote: A new o ring comes in a carby kit. But the shop that installed the kit lost both of mine. I bought a o ring kit from supercheap and used that. When i had carby problems i removed this fuel cut off switch and put a bolt in there. Over runs now and again but not every time. Excuse my ignorance but what doe it over run mean? Is it safe to run the thing without the fuel cutoff solenoid? |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|