Jimny hub nut socket, a Coily one will look the same. The hub nut is the round thing with the femail thread
| auszookers.com http://auszookers.com/forum/ |
|
| Will a Jimny hub nut socket work on a Coily? http://auszookers.com/forum/viewtopic.php?f=37&t=48649 |
Page 1 of 1 |
| Author: | Panam [ Tue Dec 02, 2014 8:24 pm ] |
| Post subject: | Will a Jimny hub nut socket work on a Coily? |
Hey guy just wondering if a jimny hub nut socket will work on a coily? As I'm trying to reach my kingpin and wheel bearings? Cause I have the infamous death wobbles hahaha Thanks in advance |
|
| Author: | Reubs [ Tue Dec 02, 2014 11:39 pm ] |
| Post subject: | Re: Will a Jimny hub nut socket work on a Coily? |
Can't help with that question - but SE Vitara hub socket would fit. If you can't get one, I have never had a problem using a hammer and a 5 or 6mm pin punch to loosen and tighten the hub nut. Never had a problem with bearing life either after re-packing old bearings and they are still good after 80K km + using this method. |
|
| Author: | Dec [ Thu Dec 04, 2014 11:25 pm ] |
| Post subject: | Re: Will a Jimny hub nut socket work on a Coily? |
Hey mate, You won't need a hub nut socket for the coily, as Reubs said you use a punch. Check out this thread for some pics. viewtopic.php?f=5&t=48105&hilit=dec Cheers Dec |
|
| Author: | shep [ Fri Dec 05, 2014 6:22 am ] |
| Post subject: | Re: Will a Jimny hub nut socket work on a Coily? |
How do you set the bearing pre load correctly with a hammer and punch? |
|
| Author: | Dec [ Fri Dec 05, 2014 7:07 am ] |
| Post subject: | Re: Will a Jimny hub nut socket work on a Coily? |
shep wrote: How do you set the bearing pre load correctly with a hammer and punch? That i can't answer good question though. I should clarify when i say you don't need a hub nut socket, this is due to the coily not using hub nuts. Cheers Dec |
|
| Author: | shep [ Fri Dec 05, 2014 4:37 pm ] |
| Post subject: | Re: Will a Jimny hub nut socket work on a Coily? |
Jimny hub nut socket, a Coily one will look the same. The hub nut is the round thing with the femail thread
|
|
| Author: | Dec [ Fri Dec 05, 2014 4:57 pm ] |
| Post subject: | Re: Will a Jimny hub nut socket work on a Coily? |
Oh you've got me there. I was only familiar with the Toyota, Nissan hexagon type hub nut socket, thanks Shep. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|