| auszookers.com http://auszookers.com/forum/ |
|
| Buying Spring Perches? http://auszookers.com/forum/viewtopic.php?f=37&t=48805 |
Page 1 of 1 |
| Author: | rwt65 [ Sun Dec 21, 2014 5:52 pm ] |
| Post subject: | Buying Spring Perches? |
If possible,can I buy spring perches? Make or buy, what do people do/use? Am putting WT diffs under my NT n chasing 4 |
|
| Author: | jdk81 [ Sun Dec 21, 2014 7:45 pm ] |
| Post subject: | Re: Buying Spring Perches? |
I bought a set from tsor (not operating any more) I didn't bother getting them again, the simple ones were fine, the one I didn't want to make myself was miles out of fitting properly, and took a lot of fiddling to get sitting nice. Careful cutting you can reuse your old perches. Or a set of verniers and set of holesaws and grinder and you can make your own |
|
| Author: | Shandy [ Sun Dec 21, 2014 8:33 pm ] |
| Post subject: | Re: Buying Spring Perches? |
I just did this job and was in the same place. I only did the rear so I've only half the story. I got some 50x100 rhs that was lying around and used a hole saw. The rear is 65mm which requires you to drill it off centre by approx. 11mm centre to centre. then cut in to two pieces. Then I put the two pieces in the vice to make sure that the spring centring dowel is level. its a 14mm if I can remember. Hope that helps. |
|
| Author: | alien [ Sun Dec 21, 2014 11:04 pm ] |
| Post subject: | Re: Buying Spring Perches? |
^^this is how mine are made. Be careful when you cut though - if you're SPUA and you leave a bit too much meat on you'll essentially be adding lowering blocks =) |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|