| auszookers.com http://auszookers.com/forum/ |
|
| WT diffs in NT http://auszookers.com/forum/viewtopic.php?f=37&t=50622 |
Page 1 of 1 |
| Author: | 4x4xzook [ Sun Jul 26, 2015 12:58 am ] |
| Post subject: | WT diffs in NT |
I have WT centre's with lockers that I want to fit to my NT 1.3 will NT axles work/fit? |
|
| Author: | Gwagensteve [ Sun Jul 26, 2015 7:43 am ] |
| Post subject: | Re: WT diffs in NT |
Pretty sure there's a write up in good tech. |
|
| Author: | 4x4xzook [ Sun Jul 26, 2015 11:07 am ] |
| Post subject: | Re: WT diffs in NT |
I was looking for it.. no luck. |
|
| Author: | shep [ Sun Jul 26, 2015 11:25 am ] |
| Post subject: | Re: WT diffs in NT |
Yep they bolt in with no mods. Only thing is a slight gearing difference. |
|
| Author: | 4x4xzook [ Sun Jul 26, 2015 11:30 am ] |
| Post subject: | Re: WT diffs in NT |
Thanks shep |
|
| Author: | cairns27 [ Sun Jul 26, 2015 1:09 pm ] |
| Post subject: | Re: WT diffs in NT |
There is some difference between NT LWB and NT SWB. bye |
|
| Author: | shep [ Sun Jul 26, 2015 2:51 pm ] |
| Post subject: | Re: WT diffs in NT |
Also nt drive shaft flange has 8mm bolt holes where wt is 10mm. I just made a 1/2nt and 1/2 wt driveshaft |
|
| Author: | 4x4xzook [ Sun Jul 26, 2015 3:15 pm ] |
| Post subject: | Re: WT diffs in NT |
Shep did you just change the flanges on either end? |
|
| Author: | shep [ Sun Jul 26, 2015 6:34 pm ] |
| Post subject: | Re: WT diffs in NT |
No just pulled the driveshaft in half on the expansion spline. |
|
| Author: | flymaster [ Sun Jul 26, 2015 6:39 pm ] |
| Post subject: | Re: WT diffs in NT |
N.T have 3.9 ratio and W.T have 3.7. You could change the diff pinion flanges to N.Track ones, but you'd then have to get your diffs pre-load set up again. Alternatively you could buy W.T tailshaft flanges to go on the diff end of your N.T tailshafts. You'd have to replace uni-joints when doing the tailshaft flange. Lockers usually run 26 spline side gears to suit c/moly axles, your front N.T axles would be 22 spline. Might be worth doing a side gear spline count to make sure. Nick |
|
| Author: | cairns27 [ Mon Jul 27, 2015 6:20 am ] |
| Post subject: | Re: WT diffs in NT |
I thought that the actual housings are different sizes. bye |
|
| Author: | flymaster [ Mon Jul 27, 2015 5:57 pm ] |
| Post subject: | Re: WT diffs in NT |
Early 1ltr ones are smaller. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|