| auszookers.com http://auszookers.com/forum/ |
|
| clutch fork boot http://auszookers.com/forum/viewtopic.php?f=37&t=50882 |
Page 1 of 1 |
| Author: | abs76abs [ Tue Aug 25, 2015 6:47 pm ] |
| Post subject: | clutch fork boot |
clutch fork boot is it possible to just replace the boot/dust cover without much effort? what has to come off / what procedure? absolute learner :/ if its too much i'll just wait and do the whole clutch later? |
|
| Author: | fordem [ Wed Aug 26, 2015 2:30 am ] |
| Post subject: | Re: clutch fork boot |
If I remember correctly, two bolts hold the clutch slave cylinder in place, remove them, remove the slave, you can let it hang from the hose for the 5~10 minutes the job takes, it's not that heavy - slip the old boot off, slip the new one on & reinstall the clutch slave - just make sure no one steps on the clutch whilst you have the slave unbolted. 15~20 minutes tops. |
|
| Author: | abs76abs [ Wed Aug 26, 2015 4:33 pm ] |
| Post subject: | Re: clutch fork boot |
thankyou for the advice ... thought something like that when I climbed under and had a look, but wanted to confirm. wanted to make sure wouldn't have to bleed system for some reason if I took that off too. Cheers |
|
| Author: | fordem [ Wed Aug 26, 2015 9:56 pm ] |
| Post subject: | Re: clutch fork boot |
Normally bleeding would only be needed if you opened up the hydraulic side, which is not required. Having said that - the reason I suggested you made sure no one presses the clutch is that it may be possible to pop the slave cylinder apart by doing that whilst it is hanging - some of us have little apprentices around whilst we work, and they can sometimes cause a lot of extra work. If the slave cylinder does come apart, bleeding will be required. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|