| auszookers.com http://auszookers.com/forum/ |
|
| Front wheel bearings??? http://auszookers.com/forum/viewtopic.php?f=37&t=51906 |
Page 1 of 1 |
| Author: | Rockman500 [ Tue Feb 09, 2016 5:04 pm ] |
| Post subject: | Front wheel bearings??? |
Gday I'm still working on 1uz setup I want to get front back on wheels so my question is all new bearings seals do I buy full hub setup or press in bearings to what I have also the brass bush in axle spigot do u buy whole lot or can u just do bush (Easley) I need axle retainers as I had to drill out bolts to remove locking ring what's the best option not nessaserely cheapest ie timken barengs good option? Also what are the best quality freewheel hubs cheers heaps |
|
| Author: | gregwatkins75 [ Tue Feb 09, 2016 5:53 pm ] |
| Post subject: | Re: Front wheel bearings??? |
Hub with built in bearing is RUBBISH in my opinion.......taken 3 sets to get mine right.... Ended up going back to an old set of hubs and pressed in new bearings... Locking hubs...A set of early vitara ones....cheap and just as good if not better than aftermarket. |
|
| Author: | Rockman500 [ Tue Feb 09, 2016 10:35 pm ] |
| Post subject: | Re: Front wheel bearings??? |
Cheers Greg I have lock-in hubs just warn out I'll press in new ones what about brass bush ??? |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|