| auszookers.com http://auszookers.com/forum/ |
|
| 2000 GV tyre clearamce http://auszookers.com/forum/viewtopic.php?f=37&t=52809 |
Page 1 of 1 |
| Author: | De zookeeper [ Tue Jul 12, 2016 9:45 pm ] |
| Post subject: | 2000 GV tyre clearamce |
Just fitted 225/75/16 bfg mtz to my 2000 grand vitara it has a 40mm dobinson lift and the front rubs at hard lock. The rear rubs when flexing. I trimed out the front but wondering what people have done for the rear i dont want to cut the guards as there is the fuel hose which will be left exposed. There is also a piece of metal which will be exposed Any help woild be greatly appreciated |
|
| Author: | henno [ Wed Jul 13, 2016 6:32 am ] |
| Post subject: | Re: 2000 GV tyre clearamce |
Where does it rub exactly? I have the same size tyres and lift and they only rubbed on the rear mud flaps and the front bar, the latter of which was fixed by bending a bracket. They do rub on the chassis at full lock but not enough to worry about. |
|
| Author: | MrRocky [ Wed Jul 13, 2016 6:36 am ] |
| Post subject: | Re: 2000 GV tyre clearamce |
I know 2 guys that run 245/75r16 with just a bit of trimming |
|
| Author: | De zookeeper [ Wed Jul 13, 2016 7:29 am ] |
| Post subject: | Re: 2000 GV tyre clearamce |
It just rubs above the mudflats in the rear. But this is only when flexing I think. Would this be a case of get a 1 inch body lift? |
|
| Author: | henno [ Wed Jul 13, 2016 9:16 am ] |
| Post subject: | Re: 2000 GV tyre clearamce |
Nope. The mudflap rubbing is nothing - I just left it. The front can be fixed with bending that little tab/bracket and lock-to-lock should be fine. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|