| auszookers.com http://auszookers.com/forum/ |
|
| Replacing uni-joints http://auszookers.com/forum/viewtopic.php?f=37&t=53159 |
Page 1 of 1 |
| Author: | cairns27 [ Wed Aug 31, 2016 1:35 pm ] |
| Post subject: | Replacing uni-joints |
I thought I knew how to do it. It doesn't knock through far enough to get the cups off.??? Tar bye |
|
| Author: | tanshi [ Wed Aug 31, 2016 1:56 pm ] |
| Post subject: | Re: Replacing uni-joints |
once they are out far enough you can get the cross out and tap them out from the inside |
|
| Author: | MrRocky [ Wed Aug 31, 2016 2:49 pm ] |
| Post subject: | Re: Replacing uni-joints |
Stock ones normally need cutting to finish them off. All the aftermarket ones seem to pop out but beware the circlips some are too big |
|
| Author: | cairns27 [ Wed Aug 31, 2016 4:08 pm ] |
| Post subject: | Re: Replacing uni-joints |
All good thanks... The new one was Toyo RUF1795...The old circlips had a curl on the end and made it easy to get out with sidecutters... The new ones are just C's, I foresee a hard time getting them out..it was just the bottom one the jackshaft. bye |
|
| Author: | anDy86 [ Thu Sep 01, 2016 11:01 pm ] |
| Post subject: | Re: Replacing uni-joints |
Have u got the right uni joints? I'm assuming the ones you have are internal circlip ones? |
|
| Author: | cairns27 [ Fri Sep 02, 2016 4:56 am ] |
| Post subject: | Re: Replacing uni-joints |
External. bye |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|