| auszookers.com http://auszookers.com/forum/ |
|
| Falcon alternator Q's http://auszookers.com/forum/viewtopic.php?f=5&t=10153 |
Page 1 of 1 |
| Author: | MrRocky [ Tue Mar 02, 2010 12:03 am ] |
| Post subject: | Falcon alternator Q's |
Just did the falc alt upgrade but the one i got didnt have the plug in it so i have just left the 2 wires not connected. It seems to charge ok between 14.8 - 15 V thats all i really care about at present. So do i have to connect em up? |
|
| Author: | gypsy [ Tue Mar 02, 2010 12:10 am ] |
| Post subject: | Re: Falcon alternator Q's |
they are 4 the light i think |
|
| Author: | Built4thrashing [ Tue Mar 02, 2010 12:17 am ] |
| Post subject: | Re: Falcon alternator Q's |
you dont need to connect the dash light but if you dont connect the signal wire it will over charge and can potentially fry any sensitive electronics you have. . signal wire needs to show battery voltage so reg cuts in and stops any over charging B4T |
|
| Author: | 11_evl [ Tue Mar 02, 2010 12:44 am ] |
| Post subject: | Re: Falcon alternator Q's |
your bat wont last long. i is overcharging and it will boil all the acid out |
|
| Author: | coneykid [ Tue Mar 02, 2010 1:11 am ] |
| Post subject: | Re: Falcon alternator Q's |
corect me if im wrong but the bosch alt off the ford use a 005 reg. so all you need to find is your alt warning lamp wire on your car and put this to the d+ pin on the alt. this will turn the reg on and allow it to regulate. if it has a RE60 reg (two pin reg) it needs both warning lamp and ignition hooked up. RE60 has L and S on it. meaning light and sense |
|
| Author: | foonji [ Tue Mar 02, 2010 1:34 am ] |
| Post subject: | Re: Falcon alternator Q's |
I just cut the plug and, put some crimp connectors on. I'll have alook tommorow and let you know which colour wire goes where. |
|
| Author: | want33s [ Tue Mar 02, 2010 2:08 am ] |
| Post subject: | Re: Falcon alternator Q's |
The bitsashitty EF-EL alt has an inbuilt reg and no D+ or L or S pins on it.... It is also self exciting... Your 1.3 loom has two wires go to the alt..Just cut the plug off and fit a pair of spade terminals, then plug into alt...... If the alt light doesn't come on with ignition you have them the wrong way around.... Swap and all will be good. |
|
| Author: | MrRocky [ Tue Mar 02, 2010 4:45 am ] |
| Post subject: | Re: Falcon alternator Q's |
cheers used the info here http://auszookers.com/index.php?name=Fo ... c&start=40 |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|