| auszookers.com http://auszookers.com/forum/ |
|
| Degree wheel http://auszookers.com/forum/viewtopic.php?f=5&t=16306 |
Page 1 of 1 |
| Author: | Damo [ Thu Oct 28, 2010 8:21 pm ] |
| Post subject: | Degree wheel |
Has anyone got a degree wheel they've used on a zook? Specifically a G16 double row multi-v type bottom pulley. I'm not keen on undoing the centre bolt because it's a PITA. I was thinking of epoxying some magnets on a aluminium disk, but keen to hear if anyone else has come up with a better idea. |
|
| Author: | ball [ Thu Oct 28, 2010 10:06 pm ] |
| Post subject: | Re: Degree wheel |
Damo wrote: Has anyone got a degree wheel they've used on a zook? Specifically a G16 double row multi-v type bottom pulley.
I'm not keen on undoing the centre bolt because it's a PITA. I was thinking of epoxying some magnets on a aluminium disk, but keen to hear if anyone else has come up with a better idea. I have a big one made by crow that has 4 slots so you can bolt it on to a bolt pattern not just a centre bolt. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|