[Cut008]

I pulled up next to a similar Vit today and noticed I sat a decent about higher than he did even though I thought my suspension was stock.

What is the standard height and where do I measure it from?

Thx.

[Ben_Sierra]

I'm not sure about what the stock height is, but are you running larger tyres or anything else that may affect the height?

Also if he had, say a big heavy bullbar on the front and a big heavy toolbox in the back it would sit lower too....

Also, he may have shagged out old springs which are sagging to make it sit lower...

[Microwire]

Yeah mine feels tall too, I've got 30's so that's a 2 inch lift from the stock 26" wheels

[tombutt]

mine feels tall but maybes thats the lift but id say he just had sagged springs

[DarkHorse]

I took some measurements when I did my lift - these are for original sagged bits:
http://www.auszookers.com/index.php?nam ... sc&start=0
About half way down the page.

[Cut008]

Thanks, I'll measure and compare.

[Cut008]

Just took a couple of measurements to compare with yours Darkhorse.

Front drivers top of wheel arch to ground.

Darks: 765mm
Mine: 800mm

Front drivers top of wheel arch to hub.

Darks: 450mm
Mine: 450mm

Sill ground clearance.

Darks: 250mm
Mine: 300mm

Rear shocks look newish...pedders comfort gas I think I read

Tyres are 235/75/15

[DarkHorse]

Mine were stock 205/70s, so that accounts for some of the difference. From memory the pedders stuff doesn't give much lift, but are much stiffer. Someone might be able to confirm/deny that.