[BRAD]

hey all took my front bar off today to find only four bolts hold it on and was thinking when i get a bullbar will i need to drill holes in the mounts or is it held by four bolts cause it dosnt seem right cheers

[larry]

mate these are the bullbar mounts that will come with the bar, they pick up the 4 stock mounting bolts. i drilled 2 m12s through the chassis to strengthen them.

i used these mounts to mount my winch bar and winched from them several times. theyre strong


EDIT: you dont need to use the m12s through the chassis. tjm designed them to just use the stock points

[DarkHorse]

That's all there is stock - 2 little M8s. Not nearly enough to trust with a recovery pull IMO.

Most of us punch two M12s through those front nubs, some (I think Christover?) wrapped a mount down around the front crossmember as well.

[christover1]

My mounts are stock.
Tho bar is lifted to match the body lift.

[christover1]

I think stock, I have not changed anything, previous owner mat have ?

[BRAD]

Might end up getting arb bar, so thats the way to go by the looks of things but if I drill the two holes im mostlikly going to drill into the bullbar aswell which os not a problem
Cool cheers guys thanks for posting pics appreciated