| auszookers.com http://auszookers.com/forum/ |
|
| how to tell if my sierra sj 40 v will bolt a 1.3 stright in http://auszookers.com/forum/viewtopic.php?f=5&t=17156 |
Page 1 of 1 |
| Author: | dyllan1 [ Tue Nov 30, 2010 6:07 am ] |
| Post subject: | how to tell if my sierra sj 40 v will bolt a 1.3 stright in |
okay so iv had a few answers and so far iv come up with this if mine has a certain chassis then a 1.3 lt and 5 speed box should bolt stright in how do i tell ? iv beed told if my chassis has the extra bolt holes and thats as far as i can get i was abit lost had a look at the engine mounts and there is a spare hole there on either side so does that mean it wil bolt stright up or please explain ?? i really need some good advice had so many mixed answers |
|
| Author: | zooky08 [ Tue Nov 30, 2010 6:14 am ] |
| Post subject: | Re: how to tell if my sierra sj 40 v will bolt a 1.3 stright in |
per engine mount uses two holes , so i dont think theres a spare. as in the title a 1.3 5 speed wont bolt straight into a sj40 |
|
| Author: | 303zuke [ Tue Nov 30, 2010 6:15 am ] |
| Post subject: | Re: how to tell if my sierra sj 40 v will bolt a 1.3 stright |
Why do you need to start a new thread for this? 1. Do you have a plastic dash, the full width, not just around the instruments? 2. Do you have 3 bolt holes on each side of the chassis engine mounts? (You have said YES, you do) If your answer to both these questions is YES, then a 1.3 engine will bolt in. |
|
| Author: | dyllan1 [ Tue Nov 30, 2010 6:20 am ] |
| Post subject: | Re: how to tell if my sierra sj 40 v will bolt a 1.3 stright in |
srry bout the new thread i have a the 3 bolt holes on each side of the chassis and i have a metal dash full width not sure if its the orginal dash thoe does that help |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|