| auszookers.com http://auszookers.com/forum/ |
|
| window washer jets http://auszookers.com/forum/viewtopic.php?f=5&t=17356 |
Page 1 of 1 |
| Author: | shakes [ Wed Dec 08, 2010 12:54 am ] |
| Post subject: | window washer jets |
The squirters on the old girl are a little sub standard so as a cheap way to kill some time was going to put two more jets with new pumps to get a lot more water onto my windscreen 
Can anyone suggest a car that has a good stream of Water and pretty common |
|
| Author: | TZAR [ Wed Dec 08, 2010 1:05 am ] |
| Post subject: | Re: window washer jets |
most modern cars have four jets but make sure the ones you get can go high enough cause there is no point getting some which are for a car with a really swept back windscreen or bling it up http://www.ryda.com.au/Aerpro-EL5W-Skul ... p/el5w.htm 
tons on ebay too |
|
| Author: | atari4x4 [ Wed Dec 08, 2010 1:17 am ] |
| Post subject: | Re: window washer jets |
on my old pootrol, i fitted washer jets to the wiper arms using cut down metal jets from a EA81 4wd Subaru Wagon, a couple of lengths of washer hose, Y junctions & some cable ties.... it would flood the windscreen & mud had no chance of sticking. |
|
| Author: | bazook [ Wed Dec 08, 2010 8:11 am ] |
| Post subject: | Re: window washer jets |
i had some on my zook you can buy them from truck shops i think but my old man used to work for volvo trucks and thats where i got mine here you go page 22 the part number is 75400 http://www.tricoproducts.com.au/pdf/trico-catalogue.pdf |
|
| Author: | Gwagensteve [ Thu Dec 09, 2010 5:58 am ] |
| Post subject: | Re: window washer jets |
I used VW/Audi pump and jets. Mine came from a SEAT Cordoba (or maybe an Ibiza?) And they are the same pump and jets used in lots of VW/Audi group cars. The VW pump press fits into the VW washer bottle, but if you pull it out, you'll notice it has a sort or barb on the inlet side that the stock sierra hose pushes onto snugly. As a result I'm running both pumps - stock sierra into VW. I have excellent washers 
Fitting these requires two rectangular holes to be cut in the bonnet - I used a dremel with a small cutoff wheel. I scored two complete pump, washer and hose sets from a pull it yourself wrecker for free. There's lots of SEAT's in wreckers as they aren't worth anything second hand, and all the bits are VW-Audi generic so quite high quality and well engineered. Steve. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|