| auszookers.com http://auszookers.com/forum/ |
|
| G16a gaskets set question http://auszookers.com/forum/viewtopic.php?f=5&t=17394 |
Page 1 of 1 |
| Author: | zooky08 [ Thu Dec 09, 2010 11:55 am ] |
| Post subject: | G16a gaskets set question |
Just ordered a vrs gasket kit for a g16a but after realising after i bought it i have a different head to the block. So i might have a big problem 
So im just wondering if a g13ba head is the same as the g16a head. Both carby heads Will the g16a gaskets(head, intake, exhaust) fit the g13ba head, or do i have to order thos three gasket seperate to the g16a vrs kit Thanks Aaron |
|
| Author: | zooky08 [ Thu Dec 09, 2010 11:07 pm ] |
| Post subject: | Re: G16a gaskets set question |
any one need to know asap, incase i have to buy more gaskets to suit
|
|
| Author: | Fatzook [ Thu Dec 09, 2010 11:10 pm ] |
| Post subject: | Re: G16a gaskets set question |
lay the gasket over the head and see if it blocks any oil or water ports. If not then it will work. |
|
| Author: | zooky08 [ Thu Dec 09, 2010 11:22 pm ] |
| Post subject: | Re: G16a gaskets set question |
Havnt got the vrs kit yet but im more worried about the intake, exhaust and valve stem seals wont fit the g13ba head from the kit |
|
| Author: | want33s [ Thu Dec 09, 2010 11:28 pm ] |
| Post subject: | Re: G16a gaskets set question |
Exhaust gasket and stem seals will fit... Not sure about the inlet, I think G16 has slightly larger ports. |
|
| Author: | zooky08 [ Thu Dec 09, 2010 11:45 pm ] |
| Post subject: | Re: G16a gaskets set question |
Ok thanks jas and fatz 
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|