Thats good to know supercheap sells em! I need an output seal too
| auszookers.com http://auszookers.com/forum/ |
|
| Transfer case seals. http://auszookers.com/forum/viewtopic.php?f=5&t=20481 |
Page 1 of 1 |
| Author: | SierraDan [ Wed Mar 30, 2011 12:55 am ] |
| Post subject: | Transfer case seals. |
Anybody know where I can get the shaft seals for a 1ltr with switch transfer? Other than the full kit from lowrange etc. Or generic seal sizes I can get from anywhere? |
|
| Author: | Ridge [ Wed Mar 30, 2011 12:58 am ] |
| Post subject: | Re: Transfer case seals. |
The input/ output seals you can get from super cheap or repco they normally have them in stock. You could try a bearing shop too. |
|
| Author: | SierraDan [ Wed Mar 30, 2011 2:25 am ] |
| Post subject: | Re: Transfer case seals. |
Awesome. Thanks. |
|
| Author: | Teracis [ Wed Mar 30, 2011 5:52 am ] |
| Post subject: | Re: Transfer case seals. |
Just got a set for my 1.3 wt case from a bearing shop, or should I say, just got a rear output seal because I must have botched it putting it in, I didn't oil it and I knew I should have but I followed the instructions and it said nothing... |
|
| Author: | SierraDan [ Wed Mar 30, 2011 6:00 am ] |
| Post subject: | Re: Transfer case seals. |
Well, as far as I know the 1.3 and the 1ltr with switch CASES are the same yeah? Only the gearing and flanges differ? So I shouldn't have any trouble finding some say in the event they say "nah only got seals for the 1.3" ? |
|
| Author: | Teracis [ Wed Mar 30, 2011 6:03 am ] |
| Post subject: | Re: Transfer case seals. |
SierraDan wrote: Well, as far as I know the 1.3 and the 1ltr with switch CASES are the same yeah? Only the gearing and flanges differ? So I shouldn't have any trouble finding some say in the event they say "nah only got seals for the 1.3"
? Can you take the case or old seal in? I can give you part numbers off the 1.3 ones I just bought? I got two but am not sure which one because there are two different seals on the transfer, he brought out the one that it said in the system and I was like shit that looks smaller than the one I had last week... so he brought out the other and it looked right, all I have to do is take back the one I don't need! |
|
| Author: | SierraDan [ Wed Mar 30, 2011 6:09 am ] |
| Post subject: | Re: Transfer case seals. |
I suppose I could take the case in. Then I'd get it right the first time. |
|
| Author: | abclarke [ Wed Mar 30, 2011 6:21 am ] |
| Post subject: | Re: Transfer case seals. |
Thats good to know supercheap sells em! I need an output seal too
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|