| auszookers.com http://auszookers.com/forum/ |
|
| Vitara Crankshaft Question http://auszookers.com/forum/viewtopic.php?f=5&t=20491 |
Page 1 of 1 |
| Author: | Derek66 [ Wed Mar 30, 2011 5:46 am ] |
| Post subject: | Vitara Crankshaft Question |
I have a 92 Manual Vitara SWB- we bought a LWB one a while back to get the manual transmission out of the LWB and replace - the auto in the SWB - When went to fit the manual to the rear of the G16a motor the end of crankshaft had a raised lip - where the auto ring gear had been bolted and that wouldnt allow the flywheel for the manual to bolt up. What is the solution - do you get the fly wheel turned down or what. Thanks in advance |
|
| Author: | billrogers [ Wed Mar 30, 2011 7:31 am ] |
| Post subject: | Re: Vitara Crankshaft Question |
I am thinking that this 'raised lip' is actually a sleeve that can be removed?? |
|
| Author: | joeblow [ Wed Mar 30, 2011 8:33 am ] |
| Post subject: | Re: Vitara Crankshaft Question |
billrogers wrote: I am thinking that this 'raised lip' is actually a sleeve that can be removed??
BINGO. |
|
| Author: | Derek66 [ Thu Mar 31, 2011 5:29 am ] |
| Post subject: | Re: Vitara Crankshaft Question |
Thank you I will have a look- JoeBlow - when you say "Bingo" - You know this for a fact? or you think that is likely |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|