Just want to make sure I put it in the right place before I reassemble it.
I can't seem to find the old 1 to remove and replace it with this 1, obviously looking in the wrong place.
Circled red below, cheers
| auszookers.com http://auszookers.com/forum/ |
|
| Where's this Transfer Case seal go? http://auszookers.com/forum/viewtopic.php?f=5&t=21646 |
Page 1 of 1 |
| Author: | Goldy [ Wed May 04, 2011 10:50 am ] |
| Post subject: | Where's this Transfer Case seal go? |
Just want to make sure I put it in the right place before I reassemble it. I can't seem to find the old 1 to remove and replace it with this 1, obviously looking in the wrong place. Circled red below, cheers
|
|
| Author: | Taylor74 [ Wed May 04, 2011 11:25 am ] |
| Post subject: | Re: Where's this Transfer Case seal go? |
Speedo drive, some kits come with the seal that go inside the speedo drive assy. |
|
| Author: | Gwagensteve [ Wed May 04, 2011 11:28 am ] |
| Post subject: | Re: Where's this Transfer Case seal go? |
Isn't the speedo drive seal just an O ring? I can't pick where that goes. Everything else makes sense though. |
|
| Author: | Goldy [ Wed May 04, 2011 11:34 am ] |
| Post subject: | Re: Where's this Transfer Case seal go? |
Gwagensteve wrote: Isn't the speedo drive seal just an O ring?
I can't pick where that goes. Everything else makes sense though. I thought the same as you... Are you saying it goes in the end of this Taylor? 
|
|
| Author: | JrZook [ Wed May 04, 2011 11:35 am ] |
| Post subject: | Re: Where's this Transfer Case seal go? |
Gwagensteve wrote: Isn't the speedo drive seal just an O ring?
I can't pick where that goes. Everything else makes sense though. Thats the outer seal from the drive 'bullet' into the case. This seal looks to be the inner one, drive gear to bullet Dan |
|
| Author: | Goldy [ Wed May 04, 2011 11:47 am ] |
| Post subject: | Re: Where's this Transfer Case seal go? |
JrZook wrote: Gwagensteve wrote: Isn't the speedo drive seal just an O ring? I can't pick where that goes. Everything else makes sense though. Thats the outer seal from the drive 'bullet' into the case. This seal looks to be the inner one, drive gear to bullet Dan Guessing that the speedo driver case above is the bullet you mean Dan? Cheers |
|
| Author: | JrZook [ Wed May 04, 2011 11:49 am ] |
| Post subject: | Re: Where's this Transfer Case seal go? |
Goldy wrote: JrZook wrote: Gwagensteve wrote: Isn't the speedo drive seal just an O ring? I can't pick where that goes. Everything else makes sense though. Thats the outer seal from the drive 'bullet' into the case. This seal looks to be the inner one, drive gear to bullet Dan Guessing that the speedo driver case above is the bullet you mean Dan? Cheers Yep, have a look down inside it. Should see the seal |
|
| Author: | Goldy [ Wed May 04, 2011 12:04 pm ] |
| Post subject: | Re: Where's this Transfer Case seal go? |
JrZook wrote: Goldy wrote: JrZook wrote: Gwagensteve wrote: Isn't the speedo drive seal just an O ring? I can't pick where that goes. Everything else makes sense though. Thats the outer seal from the drive 'bullet' into the case. This seal looks to be the inner one, drive gear to bullet Dan Guessing that the speedo driver case above is the bullet you mean Dan? Cheers Yep, have a look down inside it. Should see the seal Cheers thats it... now to get it out :\ |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|