auszookers.com
http://auszookers.com/forum/

Dizzy
http://auszookers.com/forum/viewtopic.php?f=5&t=23348		 Page 1 of 1
Author:  Jackson [ Tue Jun 28, 2011 7:01 am ]
Post subject:  Dizzy
Rather than just start a new thread. Has anyone ever seen a dizzy with a slot at the bottom? Does it drive the oil pump? It is a 4k toyota engine.

Thanks,
Author:  Fatzook [ Tue Jun 28, 2011 7:06 am ]
Post subject:  Re: Jack shaft
That doesn't really matter.

But if there is not enough spline engaement, the slip joint will flog around on the spline. Is there any movement in yours?
Author:  Jackson [ Tue Jun 28, 2011 7:09 am ]
Post subject:  Re: Jack shaft
I only just put the motor and gearbox in so I haven't driven it. So the transfer case doesn't get much of forward-back motion?

At a guess 90% of the spline would be engaged with the output shaft.
Author:  Fatzook [ Tue Jun 28, 2011 7:12 am ]
Post subject:  Re: Jack shaft
Jackson wrote:
I only just put the motor and gearbox in so I haven't driven it. So the transfer case doesn't get much of forward-back motion?

At a guess 90% of the spline would be engaged with the output shaft.


Then thats as good as it gets.

No there should not be any fore-aft movment.
Author:  Jackson [ Wed Jun 29, 2011 1:12 am ]
Post subject:  Re: Dizzy
Got another question :D
Author:  steak_knife [ Wed Jun 29, 2011 9:28 am ]
Post subject:  Re: Dizzy
Jackson wrote:
Rather than just start a new thread. Has anyone ever seen a dizzy with a slot at the bottom? Does it drive the oil pump? It is a 4k toyota engine.

Thanks,


yes I have & I think it does..... :helloo:
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/