| auszookers.com http://auszookers.com/forum/ |
|
| sierra clutch install http://auszookers.com/forum/viewtopic.php?f=5&t=23706 |
Page 1 of 1 |
| Author: | ellis [ Sun Jul 10, 2011 1:19 am ] |
| Post subject: | sierra clutch install |
hey guys just got a 1990 sierra and there is no clutch left can some1 post up a link to a good clutch install i had a look but cant find any |
|
| Author: | Scrawny [ Sun Jul 10, 2011 1:28 am ] |
| Post subject: | Re: sierra clutch install |
Pretty simple. Remove gearstick, undo wiring, remove jack shaft and front driveshaft, undo bellhousing bolts and pull gearbox back. Roll box on it's side and drop out front first. Replace clutch kit and have flywheel machined. Then reverse order |
|
| Author: | Sutho [ Sun Jul 10, 2011 2:30 am ] |
| Post subject: | Re: sierra clutch install |
take engine and gearbox out, so much easyier |
|
| Author: | ellis [ Sun Jul 10, 2011 2:57 am ] |
| Post subject: | Re: sierra clutch install |
tys for the aswers |
|
| Author: | Scrawny [ Sun Jul 10, 2011 2:59 am ] |
| Post subject: | Re: sierra clutch install |
Sutho wrote: take engine and gearbox out, so much easyier
Nooooooooooo...... why do it the hard way if you don't have to? |
|
| Author: | stockman [ Sun Jul 10, 2011 3:05 am ] |
| Post subject: | Re: sierra clutch install |
Whilst you have the box out replace the engine rear main, and box input and rear seals. |
|
| Author: | steak_knife [ Mon Jul 11, 2011 7:09 am ] |
| Post subject: | Re: sierra clutch install |
Scrawn wrote: Pretty simple. Remove gearstick, undo wiring,Drain oil, remove jack shaft and front driveshaft, undo bellhousing bolts and pull gearbox back. Roll box on it's side and drop out front first. Replace clutch kit and have flywheel machined. Then reverse order
Missed a bit... |
|
| Author: | Ben_Sierra [ Mon Jul 11, 2011 7:32 am ] |
| Post subject: | Re: sierra clutch install |
steak_knife wrote: Scrawn wrote: Pretty simple. Remove gearstick, undo wiring,Drain oil, remove jack shaft and front driveshaft, undo bellhousing bolts and pull gearbox back. Roll box on it's side and drop out front first. Replace clutch kit and have flywheel machined. Then reverse order Missed a bit... That bit does itself.... 
|
|
| Author: | Scrawny [ Mon Jul 11, 2011 7:33 am ] |
| Post subject: | Re: sierra clutch install |
steak_knife wrote: Scrawn wrote: Pretty simple. Remove gearstick, undo wiring,Drain oil, remove jack shaft and front driveshaft, undo bellhousing bolts and pull gearbox back. Roll box on it's side and drop out front first. Replace clutch kit and have flywheel machined. Then reverse order Missed a bit... Oil drains out the back and runs down your arm as you're struggling to get the box out 
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|