auszookers.com http://auszookers.com/forum/
can new wires be run into plugs for engine sensors? http://auszookers.com/forum/viewtopic.php?f=5&t=23764	Page 1 of 1

---

Author:	dp87 [ Mon Jul 11, 2011 9:49 am ]
Post subject:	can new wires be run into plugs for engine sensors?
im doing the baleno g16b conversion for my zook. the plug for the crank angle sensor and alternator dont have wires coming out of them. the wires have either been cut or pulled out. this is how i got them from the wrecker when i bought the loom and engine is there any way this can be fixed, like new wires fitted or do i have to find new plugs cheers, dan

---

Author:	xedent [ Mon Jul 11, 2011 9:50 am ]
Post subject:	Re: can new wires be run into plugs for engine sensors?
if there is no wire to join to i think that it is best to get new plugs as you dont know which wire goes where anyway ?

---

Author:	chillin24x7 [ Mon Jul 11, 2011 10:03 am ]
Post subject:	Re: can new wires be run into plugs for engine sensors?
is it possable that they forgot to add a bit of loom your after as with some of the cars ive worked on they have a few bits to it best to check out a running motor and see where bits go so you know if there is anything missing

---

Author:	Rhinoman [ Mon Jul 11, 2011 11:28 am ]
Post subject:	Re: can new wires be run into plugs for engine sensors?
Are there any pins in the connector? there is a sprung tab on the pin that must be pushed back to slide the pin out. You could then use pins from another similar connector. A replacement connector would still be the best option, I domn't know what the rest of the wiring is like but its agodd idea to keep the original wire colours to make fault-finding easier.

---

Author:	dp87 [ Fri Jul 15, 2011 7:56 am ]
Post subject:	Re: can new wires be run into plugs for engine sensors?
yes they can be re wired took them to an auto electrician.

---

Page 1 of 1	All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/