Cheers guys just got it then easy as
Thanks for all your quick help
| auszookers.com http://auszookers.com/forum/ |
|
| 1992 SJ70 Transfer rebuild http://auszookers.com/forum/viewtopic.php?f=5&t=23849 |
Page 1 of 1 |
| Author: | Dol_190 [ Thu Jul 14, 2011 11:32 am ] |
| Post subject: | 1992 SJ70 Transfer rebuild |
Hi Guys i have a 1992 SJ70 and am putting 6.5:1 reduction gears in with updated output shaft and a full rebuild.... I have a good mechanical knowledge and was wondering if any 1 could tell me how hard rebuilding the case actually is before i go pulling it apart!! any help would be greatly appreciated .... Cheers |
|
| Author: | stockman [ Thu Jul 14, 2011 11:34 am ] |
| Post subject: | Re: 1992 SJ70 Transfer rebuild |
It's very straight forward, as long as you have the right tools. |
|
| Author: | ellis [ Thu Jul 14, 2011 11:35 am ] |
| Post subject: | Re: 1992 SJ70 Transfer rebuild |
go to the lowrange website and look at the 651 and there should be a link to a good install with pics and everything |
|
| Author: | Dol_190 [ Thu Jul 14, 2011 11:36 am ] |
| Post subject: | Re: 1992 SJ70 Transfer rebuild |
Ok then.. i got a pretty full shed, what sort of speciality stuff is required?? i can my hands on most things when needed cheers |
|
| Author: | mnemonix [ Thu Jul 14, 2011 11:39 am ] |
| Post subject: | Re: 1992 SJ70 Transfer rebuild |
Having never seen one done before I was 100% hesitant to tackle mine. 31zook generously ended up rebuilding it for me while I looked on. If you follow the instructions it's very much idiot proof. I wouldn't hesitate to crack mine open and do it tomorrow now. Just make sure you've got all the tools you need to do the job first. ie: gear puller, hydraulic press, thickness gauge, shim paper, sealant etc. |
|
| Author: | Dol_190 [ Thu Jul 14, 2011 11:55 am ] |
| Post subject: | Re: 1992 SJ70 Transfer rebuild |
Cheers guys just got it then easy as Thanks for all your quick help
|
|
| Author: | Teracis [ Thu Jul 14, 2011 9:05 pm ] |
| Post subject: | Re: 1992 SJ70 Transfer rebuild |
Just remember if you attack that small cage bearing in the end of the shaft, be prepared to see it through... Apparently you can get a gear/bearing puller that is small enough to do the job though so this may be handy! |
|
| Author: | stockman [ Thu Jul 14, 2011 10:16 pm ] |
| Post subject: | Re: 1992 SJ70 Transfer rebuild |
Teracis wrote: Just remember if you attack that small cage bearing in the end of the shaft, be prepared to see it through...
Apparently you can get a gear/bearing puller that is small enough to do the job though so this may be handy!  They slide off.
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|