| auszookers.com http://auszookers.com/forum/ |
|
| vitara p/s pulley alignment http://auszookers.com/forum/viewtopic.php?f=5&t=24699 |
Page 1 of 1 |
| Author: | zooky08 [ Wed Aug 10, 2011 12:24 am ] |
| Post subject: | vitara p/s pulley alignment |
so i red on here a while ago about some one saying there p/s pump pulley doesnt line up, but i cant seem to find it. i run the vitara p/s pump on a g16 block with bent kit, and swift crank pulley. i put a straight edge across the face of the pulleys, looks to be the pump pulley is 5mm out. also i have a 4rib 830 belt and its no where near going to fit around the pulleys. i doubt a 840 will fit either. what size belt do you guys who run a vitara p/s pump and swift crank pulley cheers |
|
| Author: | Rhino [ Wed Aug 10, 2011 7:19 am ] |
| Post subject: | Re: vitara p/s pulley alignment |
On my g13 block with a swift crank pully i use a 4pk890 belt. Tho this is probably no use to you as i believe the g16b block is taller |
|
| Author: | zooky08 [ Wed Aug 10, 2011 7:51 am ] |
| Post subject: | Re: vitara p/s pulley alignment |
4kp890 might come close. I'll try that thanks Any one no why my pulleys don't line up? |
|
| Author: | barney7779 [ Wed Aug 10, 2011 9:56 am ] |
| Post subject: | Re: vitara p/s pulley alignment |
The easiest way to work out how long the belt needs to be is get a piece of string and run it around the pulley's as if it were the belt, mark where the string meets back up and measure it. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|