| auszookers.com http://auszookers.com/forum/ |
|
| Transfer case catalog http://auszookers.com/forum/viewtopic.php?f=5&t=24710 |
Page 1 of 1 |
| Author: | Bugsta [ Wed Aug 10, 2011 7:38 am ] |
| Post subject: | Transfer case catalog |
Has anyone done a complete catalog, or know of one on the net, listing all sierra cases, their High and Low range ratios, what mods can be made to them, with what available kits etc? Maybe there is another thread I don't know about? I did see a list a while back and don't remember any with High range that was close to what I would want with the Jimny. As much as I want to keep the Jimny case, dollars might prohibit that for a while. There has to be some economical solution. |
|
| Author: | SierraDan [ Wed Aug 10, 2011 11:22 am ] |
| Post subject: | Re: Transfer case catalog |
This might help? http://www.auszookers.com/index.php?nam ... pic&t=5806 |
|
| Author: | 303zuke [ Wed Aug 10, 2011 12:03 pm ] |
| Post subject: | Re: Transfer case catalog |
Those ratios are for the 2nd version of the Sierra case, the one "With Switch:, being the most widespread and the only case that aftermarket gears are made for. The 1st version Sierra case also had 2 factory options of ratios, but with weaker spline sizes and not aftermarket options, it is less sought after. Besides the ratios shown, there are also others not shown in the diagram because I haven't yet been able to nut out the tooth counts. These are: Hi 1.741, Lo 6.138 (Zeal) Hi 1.654, Lo 6.374 (Trail Tough/Rockmonster) Hi 1.75, Lo 7.875:1 (UK) |
|
| Author: | Bugsta [ Thu Aug 11, 2011 5:24 am ] |
| Post subject: | Re: Transfer case catalog |
I've been looking for my spec sheet on the T-case for the VVT engine but cannot find it. Anyone know what the MT Hi/Lo ratios are? |
|
| Author: | 303zuke [ Thu Aug 11, 2011 10:32 am ] |
| Post subject: | Re: Transfer case catalog |
Non-VVt Jimny: Hi 1.320, Lo 2.145 (with 4.09 diffs) Auto VVT Jimny: Hi 1.320, Lo 2.145 (with 4.3 diffs) VVT Jimny: Hi 1.000, Lo 2.002 (with 4.3 diffs) |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|