im pretty sure my "dust cover" or inspection plate is long gone... it doesn't seem to bother the clutch too much
| auszookers.com http://auszookers.com/forum/ |
|
| dust proofing a vitara bellhousing http://auszookers.com/forum/viewtopic.php?f=5&t=24747 |
Page 1 of 1 |
| Author: | swifty_ano [ Thu Aug 11, 2011 10:02 am ] |
| Post subject: | dust proofing a vitara bellhousing |
Last weekend chances my clutch in my vitara. In the process, I managed to bend the dust cover. Now the cover is bent and doesn't seal correctly What are my options to fix it? What's the best way to keep mud out? What has everyone else done to seal it? Why isnt the bellhousing completely sealed to start with? |
|
| Author: | stocker [ Thu Aug 11, 2011 11:01 am ] |
| Post subject: | Re: dust proofing a vitara bellhousing |
im pretty sure my "dust cover" or inspection plate is long gone... it doesn't seem to bother the clutch too much
|
|
| Author: | swifty_ano [ Thu Aug 11, 2011 7:54 pm ] |
| Post subject: | Re: dust proofing a vitara bellhousing |
I don't think mud would do it any good haha |
|
| Author: | Scrawny [ Thu Aug 11, 2011 8:18 pm ] |
| Post subject: | Re: dust proofing a vitara bellhousing |
If you get enough mud in the bell housing to affect the clutch you're in big poo! Don't worry about the plate |
|
| Author: | stocker [ Fri Aug 12, 2011 6:53 am ] |
| Post subject: | Re: dust proofing a vitara bellhousing |
swifty_ano wrote: I don't think mud would do it any good haha
Some more right foot should sought that out 
|
|
| Author: | swifty_ano [ Fri Aug 12, 2011 7:19 am ] |
| Post subject: | Re: dust proofing a vitara bellhousing |
Scrawn wrote: If you get enough mud in the bell housing to affect the clutch you're in big poo! Don't worry about the plate
I'm sure water and mud can't do it good. Hope its fine lol  will it screw up my throw out bearing though?
|
|
| Author: | Scrawny [ Fri Aug 12, 2011 7:24 am ] |
| Post subject: | Re: dust proofing a vitara bellhousing |
Wading through deep water will cause issues with your bearing, not mud. Just stay away from mud
|
|
| Author: | swifty_ano [ Fri Aug 12, 2011 7:32 am ] |
| Post subject: | Re: dust proofing a vitara bellhousing |
Would it be better to try and seal it? Why aren't they fully sealed in the.first place? Scrawn- did you mean water won't damage my bearings or will? |
|
| Author: | Scrawny [ Fri Aug 12, 2011 8:06 am ] |
| Post subject: | Re: dust proofing a vitara bellhousing |
Any bearing and water doesn't mix. It's not real necessary to have it sealed as heat and dust needs to come out somewhere. |
|
| Author: | christover1 [ Fri Aug 12, 2011 8:07 am ] |
| Post subject: | Re: dust proofing a vitara bellhousing |
without it, the water can get out faster
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|