| auszookers.com http://auszookers.com/forum/ |
|
| Coil setup help. http://auszookers.com/forum/viewtopic.php?f=5&t=24881 |
Page 1 of 1 |
| Author: | Shanej [ Wed Aug 17, 2011 1:14 am ] |
| Post subject: | Coil setup help. |
| Author: | Rusho [ Wed Aug 17, 2011 1:45 am ] |
| Post subject: | Re: Coil setup help. |
I thought you flexed it up to where you would like your set up to be and work it out that way?? |
|
| Author: | Damo [ Wed Aug 17, 2011 2:29 am ] |
| Post subject: | Re: Coil setup help. |
Shanej wrote: How do I work out the height I will need and the spring rate.
They range from 14" to 18" in height. Dobinson Springs can make them for me. It is not on the road and will only be trailered. Any help will be great... There are a lot of things to consider when doing a coil conversion, have you got the linkage design sorted? IMO you should start with 175lb springs and go from there. |
|
| Author: | got_bar_work [ Wed Aug 17, 2011 2:31 am ] |
| Post subject: | Re: Coil setup help. |
Is the car finished Ur best off getting the weight of each corner so that they have a idea of where to start What link set up are u running where r u putting the coils ie in under or outside of the chassis I would have thought that coil and shock selection would be one of the last thing to get for a build |
|
| Author: | BlueSuzy [ Wed Aug 17, 2011 2:33 am ] |
| Post subject: | Re: Coil setup help. |
And to get the correct ride height, its going to be abit of trial and error. |
|
| Author: | Shanej [ Wed Aug 17, 2011 5:35 am ] |
| Post subject: | Re: Coil setup help. |
Ok thanks. I have the design for the link set up. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|