auszookers.com
http://auszookers.com/forum/

Jimmy guys
http://auszookers.com/forum/viewtopic.php?f=5&t=25218		 Page 1 of 1
Author:  zooky08 [ Sun Aug 28, 2011 11:43 am ]
Post subject:  Jimmy guys
Can 3.9 nt 1.3 diff centers bolt into a Jimmy diff housing
Rear airlocker part number for rear is rd88 but what's the front? and is there any way a rd88 can go in the front? Custom axle I guess?

Cheers
Author:  suzooky87 [ Sun Aug 28, 2011 11:55 am ]
Post subject:  Re: Jimmy guys
I would not even bother trying to get sierra centers into a jimny as the pinion is much higher on the center itself, this will mostly affect the front, although i doubt it will fit in the front as the jinmy front center is a little smaller :).
Author:  monley [ Sun Aug 28, 2011 12:10 pm ]
Post subject:  Re: Jimmy guys
the front air locker number is rd 118.
Author:  zooky08 [ Sun Aug 28, 2011 12:16 pm ]
Post subject:  Re: Jimmy guys
Bumber, reason is I'm looking at buying a Jimmy and I wanted to keep my Sierra airlockers.
Author:  zooky08 [ Sun Aug 28, 2011 10:40 pm ]
Post subject:  Re: Jimmy guys
Can you swap jimny spindle for sierra ones and run Sierra cv's and axles.
Or is Sierra ones still to short? As I think jimny are 40mm longer?
Author:  monley [ Mon Aug 29, 2011 12:43 am ]
Post subject:  Re: Jimmy guys
zooky08 wrote:
Can you swap jimny spindle for sierra ones and run Sierra cv's and axles.
Or is Sierra ones still to short? As I think jimny are 40mm longer?


Yeh w/t track is still to short
Author:  zooky08 [ Mon Aug 29, 2011 1:10 am ]
Post subject:  Re: Jimmy guys
monkey wrote:
zooky08 wrote:
Can you swap jimny spindle for sierra ones and run Sierra cv's and axles.
Or is Sierra ones still to short? As I think jimny are 40mm longer?


Yeh w/t track is still to short
Thanks monkey
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/