frucked em....
| auszookers.com http://auszookers.com/forum/ |
|
| are these engine mounts broken? http://auszookers.com/forum/viewtopic.php?f=5&t=25886 |
Page 1 of 1 |
| Author: | CompTruck [ Sat Sep 17, 2011 1:24 pm ] |
| Post subject: | are these engine mounts broken? |
check out these guys. just need to confirm if there broken or not. as you can see the rubber bits are seperated from the other bits. one is just seperated from the metal. and one is seperated on the rubber bit |
|
| Author: | christover1 [ Sat Sep 17, 2011 1:25 pm ] |
| Post subject: | Re: are these engine mounts broken? |
na they fine, just need a bit of polishing |
|
| Author: | sleeperzook [ Sat Sep 17, 2011 1:29 pm ] |
| Post subject: | Re: are these engine mounts broken? |
It's a sketchy picture mate but yeah it looks busted. From memory it should look like a block of rubber with a bolt out either end. The metal surrounds should stop horizontal rotation but if the rubber itself is separated then they're shot but they're cheep ($30 ea when I did mine) |
|
| Author: | steak_knife [ Sat Sep 17, 2011 9:44 pm ] |
| Post subject: | Re: are these engine mounts broken? |
frucked em....
|
|
| Author: | TZAR [ Sat Sep 17, 2011 10:47 pm ] |
| Post subject: | Re: are these engine mounts broken? |
They are well and truely "pintarded" |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|