| auszookers.com http://auszookers.com/forum/ |
|
| Jimny transfer mount http://auszookers.com/forum/viewtopic.php?f=5&t=25907 |
Page 1 of 1 |
| Author: | jimny_timmy [ Sun Sep 18, 2011 9:02 am ] |
| Post subject: | Jimny transfer mount |
So I went wheelin up at Stockton beach today and managed to break the mount on my transfer case. Had to get towed off the beach and trailer it home as the drive shaft hits the chassis when driving. So just wondering if anyone has done this before? Will it be just simply unbolt and bolt a new on in? Is there stronger ones available? It looks to be cast aluminium. I'm almost certain that it's going to cost me a fourtune and almost eliminate my presence from the wheeny creek trip 
Heres a pic 
|
|
| Author: | ellis [ Sun Sep 18, 2011 9:06 am ] |
| Post subject: | Re: Jimny transfer mount |
ive done that be4 while sliding over a log a new 1 is not to much and yes its just a unbolt job |
|
| Author: | jimny_timmy [ Sun Sep 18, 2011 9:11 am ] |
| Post subject: | Re: Jimny transfer mount |
ellis wrote: ive done that be4 while sliding over a log a new 1 is not to much and yes its just a unbolt job
How much did it cost roughly mate if you can remember? |
|
| Author: | joe5701 [ Sun Sep 18, 2011 9:16 am ] |
| Post subject: | Re: Jimny transfer mount |
couple of sheps tyre deflators and a few zip ties and its all good 
|
|
| Author: | ellis [ Sun Sep 18, 2011 9:21 am ] |
| Post subject: | Re: Jimny transfer mount |
i think it was around $100 |
|
| Author: | jimny_timmy [ Sun Sep 18, 2011 10:21 am ] |
| Post subject: | Re: Jimny transfer mount |
ellis wrote: i think it was around $100
Thanks mate! |
|
| Author: | jimny_timmy [ Sun Sep 18, 2011 10:22 am ] |
| Post subject: | Re: Jimny transfer mount |
joe5701 wrote: couple of sheps tyre deflators and a few zip ties and its all good
Hmmmm... But it might catch fire 
|
|
| Author: | joe5701 [ Sun Sep 18, 2011 10:25 am ] |
| Post subject: | Re: Jimny transfer mount |
jimny_timmy wrote: joe5701 wrote: couple of sheps tyre deflators and a few zip ties and its all good Hmmmm... But it might catch fire 
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|