auszookers.com
http://auszookers.com/forum/

rear main seal relacement
http://auszookers.com/forum/viewtopic.php?f=5&t=26033		 Page 1 of 1
Author:  whincup [ Thu Sep 22, 2011 2:21 am ]
Post subject:  rear main seal relacement
ive searched and found mixed answers... ive got the engine out of my sierra and am attempting to replace the rear main. i have a service manual that tells me how to do it while the engines apart, but not how to do it while its intact... does that little housing thing have to come off or is it possible to just pull the old one out and new one in without undoing anything past the flywheel?
Author:  whincup [ Thu Sep 22, 2011 2:21 am ]
Post subject:  Re: rear main seal relacement
forgot to mention, standard sierra engine, G13BA.
Author:  royce [ Thu Sep 22, 2011 2:32 am ]
Post subject:  Re: rear main seal relacement
yep, just pull it out and swap it, I like to pack the rear hollow section of hte seal with grease and smear some on the lip so its lubed
Author:  whincup [ Thu Sep 22, 2011 2:33 am ]
Post subject:  Re: rear main seal relacement
ok thanks... now i gotta go rage the company that sold me my clutch kit because the thrust bearing or whatever its called doesnt fit :x
Author:  royce [ Thu Sep 22, 2011 2:37 am ]
Post subject:  Re: rear main seal relacement
make sure the clutch plate fits the input shaft then, there is 2 types of clutch and they cant know which is which by looking at you can they
Author:  whincup [ Thu Sep 22, 2011 3:42 am ]
Post subject:  Re: rear main seal relacement
i didnt mean "rage" literally, i work retail so know what its like... but no, the clutch plate doesnt fit... are there 2 types?? was hoping to have it back together today or tomorrow...
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/