| auszookers.com http://auszookers.com/forum/ |
|
| Idle issue on G13BA motor/carby http://auszookers.com/forum/viewtopic.php?f=5&t=26149 |
Page 1 of 1 |
| Author: | Maudie76 [ Mon Sep 26, 2011 12:55 am ] |
| Post subject: | Idle issue on G13BA motor/carby |
Hi All We have a SJ50 NT running a G13BA engine and for some reason sometimes it idles great and then other times it revs its nuts off (varies from about 1200/1300 revs to 2000/2100) not fun to drive when really revving and it isn't doing the fuel numbers any favours either. It appears the auto choke mechanism is broken too. Does anyone out there have a suggestion or a good carby to solve this problem? Thanks |
|
| Author: | mongrelzook [ Mon Sep 26, 2011 1:02 am ] |
| Post subject: | Re: Idle issue on G13BA motor/carby |
Disable auto choke all together. Sounds like it's causing it to rev up. |
|
| Author: | Reubs [ Mon Sep 26, 2011 1:05 am ] |
| Post subject: | Re: Idle issue on G13BA motor/carby |
Check your auto choke water hoses and inlet/outlet for blockages. Sounds like coolant isn't circulating past it all the time. |
|
| Author: | 607CHA [ Tue Sep 27, 2011 12:46 am ] |
| Post subject: | Re: Idle issue on G13BA motor/carby |
Mine does the same thing and sometimes if I brake hard it stalls. It looks bad when you pull up at a set of lights and it's on 2000 rpm ya just look like a wanker that wants to race. How do you disconect the auto choke. |
|
| Author: | rabrarley [ Tue Sep 27, 2011 4:41 am ] |
| Post subject: | Re: Idle issue on G13BA motor/carby |
i screwed the plate off, take the box on top of your carby off and you'll see the choke plate with to star head screws in it, take them out without dropping them down the barrel and remove plate and your sorted. car will run bit shit on start up tho, til it heats up |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|