| Author |
Message |
ridzilla

az supporter
Joined: Mon Sep 26, 2011 11:27 am Posts: 306 Location: Western Australia
Vehicle: '91 Sierra, Fluffy Dice.
|
 Posted: Mon Sep 26, 2011 11:33 am |
|
Hey guys  ,
Long time reader, first time poster...
So I've got a '91 SJ70 Sierra with the usual 2'' lift with 29'' tyres, I also have fitted a snorkel and ripped the back seats out and made up a drawer system to store recovery gear and tools.
Just wanted some advice on where to go now, with mods and extras...
I was thinking maybe a winch bar and SPOA?
Cheers,
|
|
|
|
 |
ellis
Joined: Wed Sep 08, 2010 8:28 am Posts: 445 Location: GYMPIE QLD
|
 Posted: Mon Sep 26, 2011 11:39 am |
|
|
any many ppl will tell u on here spoa will most likely be a bad idea it hard to setup right and many other things if i was u i would look at a rear locker auto locker are only about 250 to ur door and will take u a lot futher offroad
_________________ if u drive a loud toyota ute u drink rum
|
|
|
|
 |
zooky08

az supporter
Joined: Fri Nov 27, 2009 10:30 pm Posts: 3426 Location: imbil/gympie. qld
Vehicle: 03 Jimny
|
 Posted: Mon Sep 26, 2011 11:44 am |
|
|
Transfercase gears
_________________ 03 Jimny 30 km2s 75mm lift f&r locked winch
|
|
|
|
 |
shiv
Joined: Fri Sep 02, 2011 6:38 am Posts: 693 Location: Singo
Vehicle: SJ70 1993
|
 Posted: Mon Sep 26, 2011 11:49 am |
|
I put a weber in my sj70 1990, sounds great engine runs great but did my clutch backing out of the shed so havnt have a test run yet 
_________________ Lock, Drop and roll
|
|
|
|
 |
hooki

az supporter
Joined: Mon Jul 21, 2008 11:30 pm Posts: 1785 Location: perth, WA
Vehicle: 85' LWB Sierra, 01' S15
|
 Posted: Mon Sep 26, 2011 4:33 pm |
|
|
if i was in your shoes this is what i would do, in this order.
1. Rear Locker
2. RUF and longer shocks (front and rear)
3. Good set of 31's (MT)
4. Transfer gearing and appropriate transfer bracing
This setup will make your sierra a capable little rig. You could also put some extractors and a exhaust system on to provide a tiny bit more power. After this there are heaps of things you could do...powersteer, front locker, cromo cv's, 1.6L conversion etc.
As said above SPOA is hard to setup right and is illegal on WA roads. Keeping is SPUA will mean it's easy to return to stock if you need to get the car over the pits. You should definitely be able to fit some 31's with a 2inch spring lift and some gaurd hammering/cutting. These days keeping rigs nice and low seems to be the way to go.
_________________ 79' LJ80 (sold) :( 95' & 97' sierra (sold)
|
|
|
|
 |
ridzilla

az supporter
Joined: Mon Sep 26, 2011 11:27 am Posts: 306 Location: Western Australia
Vehicle: '91 Sierra, Fluffy Dice.
|
 Posted: Tue Sep 27, 2011 3:43 am |
|
Oh, I was told SPOA was a good thing... guess he lied -_-
I've currently got $1500 to play with so anything within that range is good.
I forgot to add, I've already set up a dual battery system with a Redarc Soleniod
Also, what engine mods are the best to run with... I can a barely sit on 100kph on the highway and I want to coax some more power out.
What exactly do lockers do...?
thanks again!
P.S You guys reply fast!
|
|
|
|
 |
royce

omnipotent being
Joined: Sun Jun 11, 2006 11:30 pm Posts: 17216 Location: Pluto
|
 Posted: Tue Sep 27, 2011 4:15 am |
|
|
Transfer gears will get you back on track on teh highway and a lot better control off road
Then some sliders and other barwork
If you dont know what lockers do you dont need them yet
|
|
|
|
 |
nato78

az supporter
Joined: Fri Apr 09, 2010 11:30 pm Posts: 1504 Location: Auckland, NZ
Vehicle: Yamaha scooter, 50cc
|
 Posted: Tue Sep 27, 2011 4:24 am |
|
|
For your money, IMHO you will see the best results from the following combination
Reduction gears (which will also assist your highway driving slightly by bringing your highrange ratios back to stock)
Rear auto locker, I recommend a spartan for ease of installation and use. A locker will keep both rear wheels turning in low traction situations, whereas an with and open diff all power is sent to the point of least resistance, ie when one one wheel starts spinning all power is sent to that wheel resulting in no drive to the other wheel, and you going nowhere fast
If you have any cash left over after that, get some extractors and a new zorst to help the asthmatic little engine breathe better
Hope this helps,
Nathan
|
|
|
|
 |
Fatzook

az supporter
Joined: Sat Oct 27, 2007 11:30 pm Posts: 14977 Location: The Hills
Vehicle: Vitara, NGV
|
 Posted: Tue Sep 27, 2011 4:28 am |
|
royce wrote: Transfer gears will get you back on track on teh highway and a lot better control off road
Then some sliders and other barwork
If you dont know what lockers do you dont need them yet
X2!!
The worst thing you can do to a 4wd is modify it before you know how to use it.
Forget the lockers for now. They are dangerous in inexperienced hands.
_________________ 2013 GV 1998 SV420 ute
|
|
|
|
 |
TryHard
Joined: Thu May 13, 2010 1:49 am Posts: 1041 Location: Perth
|
 Posted: Tue Sep 27, 2011 4:28 am |
|
royce wrote: If you dont know what lockers do you dont need them yet
haha Royce im going to use that Quote haha 
|
|
|
|
 |
TryHard
Joined: Thu May 13, 2010 1:49 am Posts: 1041 Location: Perth
|
 Posted: Tue Sep 27, 2011 4:29 am |
|
Fatzook wrote: royce wrote: Transfer gears will get you back on track on teh highway and a lot better control off road
Then some sliders and other barwork
If you dont know what lockers do you dont need them yet X2!! The worst thing you can do to a 4wd is modify it before you know how to use it. Forget the lockers for now. They are dangerous in inexperienced hands.
to right if i had lockers when i first got my zook i would have rolled it long time ago i just delayed the roll over haha  got carryed away with bog laps 
|
|
|
|
 |
ridzilla

az supporter
Joined: Mon Sep 26, 2011 11:27 am Posts: 306 Location: Western Australia
Vehicle: '91 Sierra, Fluffy Dice.
|
 Posted: Tue Sep 27, 2011 9:48 am |
|
|
Oh, haha
In know what they are now, had them in the old 80 series cruiser... never really knew what the were called :/
What brand should I go for the reduction gears?
_________________ If at first you don't succeed, get a bigger hammer
|
|
|
|
 |
neofitou
Joined: Wed Mar 24, 2010 10:30 pm Posts: 1088 Location: Melbourne
Vehicle: 00 Jimny, 63 Haffy
|
 Posted: Wed Sep 28, 2011 1:51 am |
|
get them from lowrange.
They are the best especially due to thier shipping. They open everything up and pack it as small as possible and use post rather than a courier.
http://www.lowrangeoffroad.com/index.ph ... -case.html
Ratio will depend on both tire size and what your driving. 4.9s are good all rounders up to 31". I ran 6.5s with 31s and it was really good.
here you can see them taking a nap under my car:

|
|
|
|
 |
got_bar_work
Joined: Sat May 15, 2010 8:30 pm Posts: 2214 Location: Brisbane
Vehicle: SQ625
|
 Posted: Wed Sep 28, 2011 6:19 am |
|
|
Transfer gears
Cut guards
31
U don't need lockers yet they take all the fun out of driving
When u do need them get both at the same time because rear locker only in a Sierra SUCK
The ass end try to overtake the front end or tries to do back flips
|
|
|
|
 |
|