| auszookers.com http://auszookers.com/forum/ |
|
| vitara help! http://auszookers.com/forum/viewtopic.php?f=5&t=26363 |
Page 1 of 1 |
| Author: | sicktara [ Mon Oct 03, 2011 6:50 am ] |
| Post subject: | vitara help! |
due to bigger tires i need to lift the vitara, and cut some guards 
im not doing a body lift, will cause to much fuss and i think they look untidy. any way, and one have some springs laying around to measue the inside diameter so i can make some spacers? not going to pay 100 dollars for a 12 dollar peice of nylon. cheers jordan |
|
| Author: | Gwagensteve [ Mon Oct 03, 2011 6:55 am ] |
| Post subject: | Re: vitara help! |
I'd say a body lift is tidier and less fuss than cutting guards, but each to their own. I reckon body work is a time consuming PITA. Steve. |
|
| Author: | stocker [ Mon Oct 03, 2011 7:14 am ] |
| Post subject: | Re: vitara help! |
Gwagensteve wrote: I'd say a body lift is tidier and less fuss than cutting guards, but each to their own.
I reckon body work is a time consuming PITA. Steve. X2 on that. either that or lift it properly... spring spacers will only limit your flex. |
|
| Author: | got_bar_work [ Mon Oct 03, 2011 8:46 pm ] |
| Post subject: | Re: vitara help! |
40 mm bump stops in the rear will clear 31' on +10 rims with a little trim Unless u go forward on the front there is heaps of fire wall loving to be done If I was u I would go new springs |
|
| Author: | SQUIRREL [ Mon Oct 03, 2011 9:21 pm ] |
| Post subject: | Re: vitara help! |
I have spacers fitted - 30mm If you like I can measure them They would be easy enough to make out of steel or alloy But check eBay , there only like &50 or so Personally I'd change springs and go they right way First and flip the strut top and see how much room you have. |
|
| Author: | sicktara [ Tue Oct 04, 2011 8:04 am ] |
| Post subject: | Re: vitara help! |
already got new springs guys  still rub
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|