auszookers.com
http://auszookers.com/forum/

Bushes for Calmini front control arms?
http://auszookers.com/forum/viewtopic.php?f=5&t=26837		 Page 1 of 1
Author:  DSzuke [ Mon Oct 17, 2011 5:39 am ]
Post subject:  Bushes for Calmini front control arms?
I need to replace the bushes on the front control arms of the Calmini kit.

I did a bit of a search but there were no definate answers...


are the bushes standard size?
Author:  stocker [ Mon Oct 17, 2011 5:43 am ]
Post subject:  Re: Bushes for Calmini front control arms?
take them out and measure the hole :)
Author:  atari4x4 [ Mon Oct 17, 2011 5:45 am ]
Post subject:  Re: Bushes for Calmini front control arms?
85Drover got a replacement bush kit not that long ago for the calmini kit, I was certain he measured the bushes & posted the info but I can't find it.
Author:  DSzuke [ Mon Oct 17, 2011 7:43 am ]
Post subject:  Re: Bushes for Calmini front control arms?
stocker wrote:
take them out and measure the hole :)



I probably will have too!
Author:  DSzuke [ Mon Oct 17, 2011 7:45 am ]
Post subject:  Re: Bushes for Calmini front control arms?
atari4x4 wrote:
85Drover got a replacement bush kit not that long ago for the calmini kit, I was certain he measured the bushes & posted the info but I can't find it.



I found that thread in the search but the last post was something like "I'll get around to it"...

85Drover, how'd you go?
Author:  DSzuke [ Thu Nov 10, 2011 4:25 am ]
Post subject:  Re: Bushes for Calmini front control arms?
just for closure to this...

Gemini rear trailing arm bushes are a good fit. I think it was 1984 - 94 models. I had to re-use my sleeves but they pressed in fine.


I got them from a local supplier but the company was:


Whiteline Plus

part number W61490


I don't know if all the Calmini holes are the the same but these fit the front control arms :)
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/