auszookers.com
http://auszookers.com/forum/

need help from a vic
http://auszookers.com/forum/viewtopic.php?f=5&t=27358
Page 1 of 1

Author:  mattr [ Thu Nov 03, 2011 7:10 am ]
Post subject:  need help from a vic

hey all.

looking at getting a GV from the ashwood area. hoping someone on here might be able to have a look and give me an honest answer as to if it is worth it or not? willing to buy a carton for someone who can help.

car is getting new rear bumper atm and will be ready to look at next week. I will organise with the seller if someone can. then maybe another carton if i buy and need to get taken to transport company.

hope someone can help. can call me on 0402788079 if thats easier

cheers
Matt

Author:  suzukikid [ Thu Nov 03, 2011 8:39 am ]
Post subject:  Re: need help from a vic

built4 thrashing will be ya best bet....he has 2 and is from out that side...if ashwood is where im thinkin it is!haha

Author:  mattr [ Thu Nov 03, 2011 8:10 pm ]
Post subject:  Re: need help from a vic

cheers, ill try to contact him

Author:  sierrajim [ Fri Nov 04, 2011 12:21 am ]
Post subject:  Re: need help from a vic

That's also not too far from Dank (KPD). Dank is also the guy that would be able to hook you up with all the bits you'll be wanting to fit to it.

Author:  mattr [ Fri Nov 04, 2011 12:24 am ]
Post subject:  Re: need help from a vic

cheers sierrajim
ill try to get in contact with him too.

Author:  dank [ Fri Nov 04, 2011 12:34 am ]
Post subject:  Re: need help from a vic

Yeah thats just down the road. pretty flat out at the moment though but next week might be ok after work to go down and have a look.

Give me a call on 0428 292 839 once you get yourself sorted out and organise a Time anytime after 5pm next week and I'll be right to go. Coopers Pale ale goes down a treat :)

Author:  mattr [ Fri Nov 04, 2011 3:25 am ]
Post subject:  Re: need help from a vic

cheers, guy said it is getting new rear bar and tail lights as it has been backed into at shopping centre. should be ready next week anyway. ill pm you the link for it.

good to see your a pale man too:)

Author:  Built4thrashing [ Fri Nov 04, 2011 8:28 am ]
Post subject:  Re: need help from a vic

hey Dank. when we climbing???? could team up and have a look on the way to a climbing ctr????


hmmm Beer. :cheers:

Author:  Built4thrashing [ Fri Nov 11, 2011 4:33 am ]
Post subject:  Re: need help from a vic

Went to look at this car. Not sure what this guy was looking at when he said it had no damage to under the bonet area due to its small carpark accident. Radiator support has been damaged and thats a structural component and has to be replaced to get a RWC. other than that there are oil leaks and torn seats and the bonet/grill and bumper to replace.....


Would make an awsome fixer upper car for someone that knew how.

Author:  sogone [ Fri Nov 11, 2011 4:37 am ]
Post subject:  Re: need help from a vic

And at about 60% of asking price? :P

Author:  Built4thrashing [ Fri Nov 11, 2011 4:55 am ]
Post subject:  Re: need help from a vic

be nice to know what the rad support panel would be worth.


It wouldnt be to bad if the rego didnt have to be canceled as then it wouldnt have to go over the pits to get rego'd. so only good to a Vic buyer.

Author:  mattr [ Fri Nov 11, 2011 6:48 am ]
Post subject:  Re: need help from a vic

checked price, hard to describe which part it is. suzi wreckers here said they take the whole support out and replace the whole lot. about $220 if its the right support

Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/