| auszookers.com http://auszookers.com/forum/ |
|
| 1.3 NT hard top wanna run 1.3 WT centers http://auszookers.com/forum/viewtopic.php?f=5&t=27568 |
Page 1 of 1 |
| Author: | Fast50 [ Thu Nov 10, 2011 3:27 am ] |
| Post subject: | 1.3 NT hard top wanna run 1.3 WT centers |
Do those go straight in?? With out gearing and do my axles fit.. I want to weld the rear too. My hard top is stock and I wanna go wheel it this weekend any thing I should remove 1st?? Any help much appreciated... |
|
| Author: | Fatzook [ Thu Nov 10, 2011 3:28 am ] |
| Post subject: | Re: 1.3 NT hard top wanna run 1.3 WT centers |
Yes the centres are interchangable without mods. But your NT centres have better ratios for offroad use. |
|
| Author: | royce [ Thu Nov 10, 2011 3:30 am ] |
| Post subject: | Re: 1.3 NT hard top wanna run 1.3 WT centers |
the bolt spacing on the flanges for the tailshafts are different so you need to make up something there |
|
| Author: | Fast50 [ Thu Nov 10, 2011 3:36 am ] |
| Post subject: | Re: 1.3 NT hard top wanna run 1.3 WT centers |
Thank u so wt housings with NT centers are the go.. .. Should the sway bars be removed for wheelin |
|
| Author: | rpmwrx [ Thu Nov 10, 2011 3:39 am ] |
| Post subject: | Re: 1.3 NT hard top wanna run 1.3 WT centers |
Fast50 wrote: Thank u so wt housings with NT centers are the go..
.. Should the sway bars be removed for wheelin Yes... |
|
| Author: | just_cruizin [ Thu Nov 10, 2011 6:34 am ] |
| Post subject: | Re: 1.3 NT hard top wanna run 1.3 WT centers |
NT centers will fit the housings, take it you have modded the housings to suit the spring spacing |
|
| Author: | Fast50 [ Thu Nov 10, 2011 10:08 am ] |
| Post subject: | Re: 1.3 NT hard top wanna run 1.3 WT centers |
No I have them sitting there.. Is it just new hangers?? And I guess at the same time SOA as well.. So I will need a steer kit with arms and shit hey??? Thanks again |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|