The driveshafts with the splines have a dot to line up
Uni's have to be a mirror image.
| auszookers.com http://auszookers.com/forum/ |
|
| Sierra tail shaft http://auszookers.com/forum/viewtopic.php?f=5&t=27608 |
Page 1 of 1 |
| Author: | Jackson [ Fri Nov 11, 2011 10:05 pm ] |
| Post subject: | Sierra tail shaft |
G'day. How is the back drive shaft meant to be aligned. I was always told it was like this )--------( but even after putting new unis in I am still getting some funky vibes. Thanks |
|
| Author: | 31zook [ Fri Nov 11, 2011 10:26 pm ] |
| Post subject: | Re: Sierra tail shaft |
Did you feel for movement in the jack shaft? Or tyres not balanced, or movement in the diff flange? Or tcase for that matter? |
|
| Author: | Jackson [ Fri Nov 11, 2011 10:36 pm ] |
| Post subject: | Re: Sierra tail shaft |
Changed the uni's in the jack shaft it is all good. I assume you just wobble the diff flange? It was solid. Same with tcase flanges. Tyres might be it. When they were put on the fella said it took a fair bit of weight to balance. |
|
| Author: | Red89 [ Fri Nov 11, 2011 10:39 pm ] |
| Post subject: | Re: Sierra tail shaft |
This thread on Zuwharrie is a how to phase the driveshaft properly. http://bbs.zuwharrie.com/content/topic,16725.15.html |
|
| Author: | BlueSuzy [ Sat Nov 12, 2011 12:00 am ] |
| Post subject: | Re: Sierra tail shaft |
The driveshafts with the splines have a dot to line up
Uni's have to be a mirror image. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|