A bigger hammer doesn't always pay off
| auszookers.com http://auszookers.com/forum/ |
|
| Transmission Rebuild http://auszookers.com/forum/viewtopic.php?f=5&t=27609 |
Page 1 of 1 |
| Author: | Dale [ Fri Nov 11, 2011 11:55 pm ] |
| Post subject: | Transmission Rebuild |
Hi All, I'm rebuilding my transmission today and I cant get the case apart? I have tried to use a screwdriver in the slot, however it doesn't come apart. There is loads of silicon holding it together. Any ideas? Thanks Dale |
|
| Author: | Scrawny [ Fri Nov 11, 2011 11:57 pm ] |
| Post subject: | Re: Transmission Rebuild |
Screwdriver in the slot then whack with a hammer. It just needs prying apart, as long as ALL the bolts are out? |
|
| Author: | Damo [ Sat Nov 12, 2011 12:43 am ] |
| Post subject: | Re: Transmission Rebuild |
Have you got the front cover off inside the bellhousing? You've got a copy of the FSM and are following that right? |
|
| Author: | Dale [ Sat Nov 12, 2011 12:54 am ] |
| Post subject: | Re: Transmission Rebuild |
Yep, missed the two bolts at the top. However I have now damaged the case. Anyone have a 1.3 WT 91 transmission case? In Vic? Thanks Dale |
|
| Author: | Daves4wd [ Sat Nov 12, 2011 12:58 am ] |
| Post subject: | Re: Transmission Rebuild |
Use a rubber mellot same impact but softer on the metel |
|
| Author: | Scrawny [ Sat Nov 12, 2011 12:58 am ] |
| Post subject: | Re: Transmission Rebuild |
How bad? Post some pics, it might be salvageable? |
|
| Author: | Dale [ Sat Nov 12, 2011 1:35 am ] |
| Post subject: | Re: Transmission Rebuild |
A bigger hammer doesn't always pay off
|
|
| Author: | Scrawny [ Sat Nov 12, 2011 1:47 am ] |
| Post subject: | Re: Transmission Rebuild |
That's only the bellhousing, I wouldn't stress too much about it. |
|
| Author: | want33s [ Sat Nov 12, 2011 5:37 am ] |
| Post subject: | Re: Transmission Rebuild |
Replace it if you can source one otherwise just drill a small hole at the end of the crack and call it good. |
|
| Author: | also76 [ Sat Nov 12, 2011 7:18 am ] |
| Post subject: | Re: Transmission Rebuild |
yeah its bellhousing man, you'll be sweet, get some devcon to fix it so the crack dont spread..... best shite ever ! a guy i work with mate a keyway for his crank gear out of devcon... drives in on limiter alllll day long and no worries. |
|
| Author: | ridzilla [ Sat Nov 12, 2011 10:39 am ] |
| Post subject: | Re: Transmission Rebuild |
Drill a hole at the end of the crack, then weld it up? Easy done |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|