auszookers.com http://auszookers.com/forum/
fitting 6.5s detent balls http://auszookers.com/forum/viewtopic.php?f=5&t=27664	Page 1 of 1

---

Author:	jonno_racing [ Mon Nov 14, 2011 4:15 am ]
Post subject:	fitting 6.5s detent balls
hey guys trying to fit a set of 6.5s done it before however i was given the case in bits.. there is 3 detent balls.. however one is a few mm bigger than the other?? is this right?? and what order do they go in?? the bigger ball doesnt fit in any of the holes... Phil

---

Author:	pyrohamish [ Mon Nov 14, 2011 4:46 am ]
Post subject:	Re: fitting 6.5s detent balls
probably for fifth gear/reverse switch

---

Author:	SierraDan [ Mon Nov 14, 2011 5:05 am ]
Post subject:	Re: fitting 6.5s detent balls
Nope. Two are for either side of the shift rail. One is for 4wd switch.

---

Author:	also76 [ Mon Nov 14, 2011 5:05 am ]
Post subject:	Re: fitting 6.5s detent balls
Spot on. its reverse switch

---

Author:	jonno_racing [ Mon Nov 14, 2011 5:09 am ]
Post subject:	Re: fitting 6.5s detent balls
Ah yes. so we are missing one smaller ball.

---

Author:	royce [ Mon Nov 14, 2011 5:13 am ]
Post subject:	Re: fitting 6.5s detent balls
Why are 2 people talking about a ball for a reverse switch in a thread about A TRANSFER CASE give yourself a week holiday from posting

---

Author:	31zook [ Mon Nov 14, 2011 5:51 am ]
Post subject:	Re: fitting 6.5s detent balls

---

Author:	denty802 [ Mon Nov 14, 2011 6:54 am ]
Post subject:	Re: fitting 6.5s detent balls
the instructions that come from low range off road mention the different balls, ie sizing and where they go i think there is a link tothe instructions floating somewhere if you havent got a paper copy

---

Author:	Aaron [ Mon Nov 14, 2011 6:57 am ]
Post subject:	Re: fitting 6.5s detent balls
http://www.lowrangeoffroad.com/index.ph ... gears.html The destructions/ instructoions are in there

---

Page 1 of 1	All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/