| auszookers.com http://auszookers.com/forum/ |
|
| What Crimps For 1.2mm Steel Cable http://auszookers.com/forum/viewtopic.php?f=5&t=28062 |
Page 1 of 1 |
| Author: | fritter [ Sat Nov 26, 2011 7:50 am ] |
| Post subject: | What Crimps For 1.2mm Steel Cable |
I was rebuilding my manual window regulator today and I'm having trouble finding strong enough crimps for the ends of the cables. I tried the ones pictured below, but the cable just pulled out when under pressure. The second pic shows the slots they need to fit into. I could tie a knot in the ends, but I'm looking for something a little better than that. Anyone got any ideas for what I can use? 
|
|
| Author: | Daves4wd [ Sat Nov 26, 2011 8:15 am ] |
| Post subject: | Re: What Crimps For 1.2mm Steel Cable |
A Small blob of weld on the end of it?? Maybe it's just a idea |
|
| Author: | jimbo_jones [ Sat Nov 26, 2011 8:18 am ] |
| Post subject: | Re: What Crimps For 1.2mm Steel Cable |
Daves4wd wrote: A Small blob of weld on the end of it?? Maybe it's just a idea
thats not a bad idea use a oxy set |
|
| Author: | fritter [ Sat Nov 26, 2011 9:02 am ] |
| Post subject: | Re: What Crimps For 1.2mm Steel Cable |
Thanks guys. Haven't got an oxy set. But I'll try my stick welder. |
|
| Author: | pyrohamish [ Sat Nov 26, 2011 11:39 am ] |
| Post subject: | Re: What Crimps For 1.2mm Steel Cable |
I used a lil mini blowtorch to braze a lug on to my accel cable to change the length |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|