auszookers.com
http://auszookers.com/forum/

Torque settings.
http://auszookers.com/forum/viewtopic.php?f=5&t=28071		 Page 1 of 1
Author:  sniper [ Sat Nov 26, 2011 2:04 pm ]
Post subject:  Torque settings.
Does any body have the correct torque settings for the clutch and Flywheel on a 16b Vitara motor... Got a screwed clutch and whilst its apart may need to look at getting the flywheel machined. Easy to pull apart but dont have the settings for the bolt back on.

Any assistance greatly appreciated.
Author:  steak_knife [ Sat Nov 26, 2011 4:56 pm ]
Post subject:  Re: Torque settings.
Flyingwheel 70-80nm
Pressure plate 18-28nm...


:helloo:
Author:  steak_knife [ Sat Nov 26, 2011 4:56 pm ]
Post subject:  Re: Torque settings.
Oh, toktite on the flywheel bolt's please... :P
Author:  whincup [ Sat Nov 26, 2011 8:27 pm ]
Post subject:  Re: Torque settings.
steak_knife wrote:
Oh, toktite on the flywheel bolt's please... :P


X2. its a bitch to have to pull everything apart just to retighten the flywheel bolts after about half an hour of driving. found that out the fun way :roll:
Author:  Scrawny [ Sat Nov 26, 2011 8:36 pm ]
Post subject:  Re: Torque settings.
And do get the flywheel machined, $50 well spent

What's toktite? :P
Author:  steak_knife [ Sat Nov 26, 2011 9:47 pm ]
Post subject:  Re: Torque settings.
Scrawn wrote:
And do get the flywheel machined, $50 well spent

What's toktite? :P


It's a formation found in the depth's of the of the highest point of the lower bank's of an oyster's teeth.... :helloo:
Author:  Scrawny [ Sat Nov 26, 2011 10:34 pm ]
Post subject:  Re: Torque settings.
steak_knife wrote:
Scrawn wrote:
And do get the flywheel machined, $50 well spent

What's toktite? :P


It's a formation found in the depth's of the of the highest point of the lower bank's of an oyster's teeth.... :helloo:


Oh... must be pretty rare 8O
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/