| auszookers.com http://auszookers.com/forum/ |
|
| Vit front diff! http://auszookers.com/forum/viewtopic.php?f=5&t=2820 |
Page 1 of 1 |
| Author: | suzukikid [ Fri Aug 22, 2008 11:12 pm ] |
| Post subject: | Vit front diff! |
Just wanna now what diff and stuff you use to replace the alloy diff stuff on the vit that arrives at mine soon....... CHEERS |
|
| Author: | Bruce [ Fri Aug 22, 2008 11:23 pm ] |
| Post subject: | Re: Vit front diff! |
More info please. Year of Vit. rear diff ratio etc. |
|
| Author: | royce [ Fri Aug 22, 2008 11:52 pm ] |
| Post subject: | Re: Vit front diff! |
providing the alloy diff is ok you need a steel housing and carrier out of a GV, 2000 onwards manual have them and 2003 onwards have them then get your gears and hemisphere fitted to the steel carrier and slot it all into the front |
|
| Author: | suzukikid [ Sat Aug 23, 2008 3:46 am ] |
| Post subject: | Re: Vit front diff! |
92 manual vit got the front alloy diff that is apparently weak as do you replace the diff and housing or just the housing? |
|
| Author: | royce [ Sat Aug 23, 2008 12:19 pm ] |
| Post subject: | Re: Vit front diff! |
the only thing you keep is the crownwheel, pinion and hemisphere (if you arent fitting an airlocker) |
|
| Author: | suzukikid [ Mon Aug 25, 2008 3:47 pm ] |
| Post subject: | Re: Vit front diff! |
Will be goin an air locker soonish..... So when that go's in all i need is the diff housing yeah? |
|
| Author: | royce [ Mon Aug 25, 2008 3:54 pm ] |
| Post subject: | Re: Vit front diff! |
you need the housing (big bit that the axles and centre bolt into) and the carrier (round bit the pinion and locker bolt into) |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|