| auszookers.com http://auszookers.com/forum/ |
|
| how to undo bolt http://auszookers.com/forum/viewtopic.php?f=5&t=28267 |
Page 1 of 1 |
| Author: | Kyle [ Sat Dec 03, 2011 2:39 am ] |
| Post subject: | how to undo bolt |
i am trying to replace the front and rear main seals, but i am stuck trying to get of the centre crank bolt. any tips on how to do it |
|
| Author: | Aaron [ Sat Dec 03, 2011 3:08 am ] |
| Post subject: | Re: how to undo bolt |
turn it left? |
|
| Author: | Kyle [ Sat Dec 03, 2011 3:11 am ] |
| Post subject: | Re: how to undo bolt |
yeh im not stupid. its really tight, the rattle gun wont undo it, i was wondering if there was a special way to do it |
|
| Author: | 85Drover [ Sat Dec 03, 2011 3:15 am ] |
| Post subject: | Re: how to undo bolt |
Rostoff. |
|
| Author: | Jackson [ Sat Dec 03, 2011 3:18 am ] |
| Post subject: | Re: how to undo bolt |
Just double check before you do it, but put the spanner on and run a pipe down to the floor then hit the key it should spin the right way to undo it... Then go back to your rattle gun... Then swing off it for a while... Then come back tomorrow and you'll undo it with your fingers 
|
|
| Author: | laurie [ Sat Dec 03, 2011 3:31 am ] |
| Post subject: | Re: how to undo bolt |
Jackson wrote: Just double check before you do it, but put the spanner on and run a pipe down to the floor then hit the key it should spin the right way to undo it... Then go back to your rattle gun... Then swing off it for a while... Then come back tomorrow and you'll undo it with your fingers
yes the starter undid mine took a couple of hits though and a rattle or two |
|
| Author: | Kyle [ Sat Dec 03, 2011 4:24 am ] |
| Post subject: | Re: how to undo bolt |
The engine is out if the car but |
|
| Author: | Damo [ Sat Dec 03, 2011 5:02 am ] |
| Post subject: | Re: how to undo bolt |
Kyle wrote: The engine is out if the car but
Make something to lock the crank to the block. Figure a way to hold the engine block so it doesn't move, then get your breaker bar with a length of pipe on it to undo it |
|
| Author: | Lockie666 [ Sat Dec 03, 2011 5:03 am ] |
| Post subject: | Re: how to undo bolt |
Damo wrote: Kyle wrote: The engine is out if the car but Make something to lock the crank to the block. Figure a way to hold the engine block so it doesn't move, then get your breaker bar with a length of pipe on it to undo it x2 if that doesn't work, get a longer breaker bar and a longer pipe |
|
| Author: | royce [ Sat Dec 03, 2011 5:06 am ] |
| Post subject: | Re: how to undo bolt |
Damo wrote: Kyle wrote: The engine is out if the car but Make something to lock the crank to the block. Figure a way to hold the engine block so it doesn't move, then get your breaker bar with a length of pipe on it to undo it all this but once the crank is locked use the rattle gun, they arent effective when the crank can move around |
|
| Author: | steak_knife [ Sat Dec 03, 2011 5:33 am ] |
| Post subject: | Re: how to undo bolt |
royce wrote: Damo wrote: Kyle wrote: The engine is out if the car but Make something to lock the crank to the block. Figure a way to hold the engine block so it doesn't move, then get your breaker bar with a length of pipe on it to undo it all this but once the crank is locked use the rattle gun, they arent effective when the crank can move around & if that doesn't work, get a new rattle gun, or oil your's.... |
|
| Author: | rick1970 [ Mon Dec 05, 2011 5:42 pm ] |
| Post subject: | Re: how to undo bolt |
steak_knife wrote: royce wrote: Damo wrote: Kyle wrote: The engine is out if the car but Make something to lock the crank to the block. Figure a way to hold the engine block so it doesn't move, then get your breaker bar with a length of pipe on it to undo it all this but once the crank is locked use the rattle gun, they arent effective when the crank can move around & if that doesn't work, get a new rattle gun, or oil your's.... And there are rattle guns and rattle guns. If your using a $50 supercrap 'bargin', you may as well try undoing it with your teeth. A few drops of oil every now and then can do wonders for a rattle guns usable life span. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|